DIR 8818 User manual

INSTRUCTIONMANUAL
Tranquility
8818
®

Specification
Technical data
Size
Load
Net weight
Adjust height range
Padding
Leather
200*80*65-83cm
USAUK
200kg
103kg
65～83cm
8cm sponge
PU/PVC
78 3/4”*31 1/2”*25 1/2”-32 5/8”
440lb
227lb
25 1/2”～32 5/8”
3”sponge
PU/PVC
32 5/8”
25 1/2”
78 3/4”
27 1/2”

Remote controller:
① SW1
Press turn on the remote;press again ,turn off the remote ,the bed would
be back to original position. Then press one more time during the process,the bed
would be stopped
② SW2
Press whole bed raise up,press whole bed go down
③ SW3
Press or control the bed the Incline upward
④ SW4
Press or control the bed the Incline Downward
⑤ SW5
Press or control the backrest up and down.
⑥ SW6
Press or control the footrest up and down
⑦ SW7
A long press to start the memory function
⑧ SW8
press Memory state 1
⑨ SW9
press Memory state2
⑩ SW10
press Memory state 3

●Usage method：
Backrest height adjustment：
press or to adjust the angle of recline up for the whole bed.（Backrest section rise but
footrest section keep stationary）or come to plat status. As below picture:

Footrest height adjustment：
press or to adjust the angle of re-
cline down for the whole bed. (Backrest section
keep stationary but footrest section rise up) or
come to plat status. As below picture:
Backrest adjustment：
Press or to control backrest recline
angle. As below picture:
Footrest adjustment：
Press or to control footrest recline
angle. As below picture:

Handle of gas piston
Handle of gas piston
Recover
status
Adjust
status
Handrest adjustment：
See below picture: as per arrow direction, keep
pressing the gas piston and meanwhile press the
handrest to the angle you want. Or it will recover by
opposite method.
The suggestive instructions:
1. This electric massage bed uses a three-wire power cable. Meanwhile it should be inserted into the
three-hole outlet where there is a ground electrode. And it should be assured that it can be connected
to the ground electrode smoothly so that it can prevent people from getting electric shock while
functioning normally.
2. All the plugs, buttons and other components connected to the power cable must not dip in the
water or other liquid.
3. It is forbidden to put your hands, feet, head or other part of the body into the gap while massage
chair is running when you press the manual control panel or the foot control panel.
4. It is prohibited to use when plugs, buttons and other components connected to the power cable
are broken.
5. It should be noticed that the frequency is 6min/h when the motor of this massage chair is used.
6. The maintenances should not be dealt with without official training.

Attentions
1. Someone with osteoporosis or heart problem should
not use this massage chair.
2. Women being pregnant or in menstruation should not
use this massage chair.
3. Someone inured or with disabilities should not use this
massage chair.
4. Children under 14 years old without any supervision
and someone unconscious should not use this massage
chair.
5. Breakages of the power cable and plug should be
eliminated before it’s normally used. Breakages should be
dealt with by someone professionals or service providers.
6. The voltage should accord with the safety voltage
before it’s officially used. And the wrong voltage may lead
to the breakdown of the product.
7. Wet hand is not allowed to touch power to avoid shock.
8. The product should not plug in before it’s already
installed.
9. The power cable should be put away so that pedestrian
will not trip up and fall.
10. The appearance of the product should cleaned by the
use of the soft towel with diluted neutral detergent.
11. It should be unplug when it’s not used.
12. Do not dismount this product without any authorization.
Please inform the official service providers to deal with the
maintenances

Phenomenon Diagnosis Operation of elimination
Screw loosen Tighten all the screws
The fuse has burned out. Replace the fuse.
Maintenances
1. Daily cleaning
You can wipe out the dust by using soft dry towel.
2. Eliminating the heavy dirt
As we all know, it is hard to eliminate the heavy dirt by using normal dry towel. In this case, you can
use soft towel with diluted neutral detergent to clean it first. And then you can use dry towel to scrub.
3. It’s prohibited to use benzene, diluent, gasoline or other solvent
These solvents may damage the leather or it may cause the corrosion of the products’ appearance.
4. Storage and operating environment
Don’t put the product under the strong sunlight and moisture environment. Otherwise it may cause the
damages of the product.
5. It is allowed to use this product under the temperature from -5 ° c to 50 ° c and the humidity from
45% to 85%.
Remarks: It will be not informed if the improvements of the product do not influence appearance and
function.
Press the button on the remote but without
any responses.
1. The function of control button has reached
to maximum.
2. To check if the power plug is connected.
3. To check if each connecting plug of the
transformer is connected.
1. Try to press other control button.
2. Disconnect the power plug and connect it
again.
3. Disclose the chassis. Discharge the plug
and connect it again.
Letting out noises and shaking while going up
and down
The light is still off although the switch is on.
Fault Diagnosis
If there is something wrong when you use the product, please try to check and eliminate the
wrong operation as followings.

66 Rea Street South
Birmingham
B5 6LB
UK
-----------------------------
Tel:
[phone]
-----------------------------
Email:
[email protected]
DIR BIRMINGHAM
[email protected]
Unit 1 River Road
Business Park
33 River Road, Barking
Greater London
IG11 0DA
UK
-----------------------------
Tel:
[phone]
--------- --------------------
Email:
DIR LONDON
Unit 20, Goldenbridge Ind.
Estate Tyrconnell Road
Inchicore
Dublin 8
Republic of Ireland
------------------------------
Phone:
[phone]
------------------------------
Email:
[email protected]
DIR IRELAND
USA
Tel:
sale
DIR NEW YORK
575 Underhill Blvd.
Suite 170
Syosset, NY 11791
---------------------------
[phone]
[phone]
-------- ---------------------
Email:
[e-mail]
Warranty
Product care
The warranty period is one year. DIR warrants to you, the original buyer, that goods shall be free of defects in material and/or
workmanship attributable to manufacture for one year from date of s receipt of product. Damage resulting from improper handling
after merchandise is received, or from exposure to weather or extreme atmospheric conditions is not covered by the warranty.
For any other information please contact our support team:
Brush away excess hair
Clean surface with damp cloth or use
simple soap & water solution.
Avoid using corrosive clean-
ing agents such as bleaches.
Do not remove upholstery for
cleaning