Directive Systems & Engineering DSE1376LY User manual


DSE1376LYRev12/13
DirectiveSystems&Engineering
2702RodgersTerrace
Haymarket,VA20169‐1628
www.directivesystems.com
703‐754‐3876

2304MHzLoopYagi,ModelDSE1376LY

SPECIFICATIONS
Frequency range: 2.28 to 2.35 GHz Gain: ≅23.4 dBi
Number of elements: 76 3 dB Beamwidth
Boom length: 144 inches (E plane): ≅10.7º
Boom diameter: 0.5” & 0.75” sub-boom F/B ratio: >25 dB
Mast diameter: 2 in. max Maximum Power: 300 W average
Weight: (assembled) 5.2 pounds assembled Stacking distance: 24.5 inches vertical
Connector: Type-N female 25.25 in. horizontal
Wind area: 0.95 sq. ft.



ASSEMBLYINSTRUCTIONS
1) Unpack the antenna and locate the hardware package. Antennas are shipped in two
sections. In addition, a 71" long "sub-boom" is supplied. (See drawing above.) The boom is
broken between directors 37 & 38. Remove D38 and D39 from the front boom section and
slide the two boom pieces together. Use the alignment marks on the boom to correctly
connect the boom pieces. Align the elements. Replace D38 & D39 and retighten.
2) Attach the two 3 x 4" sub boom plates to the 1/2" boom and the attached angle
brackets with the 8-32 x 3/4" hardware provided. Install the sub boom to the two plates with
the mounting plate holes offset towards the rear (for mechanical balance). Use the 8-32 x 1
1/4" machine screws to attach the 3 x 4” plates and the main (3 ½ X 4”) boom to mast plate.
Install the 1 1/2" U-bolt in the holes provided in the mast plate.
3) Attach the feedline and tape it to the bottom of the boom & sub-boom. The connector
should be sealed with silicone RTV or equivalent.
4) Straighten any misaligned elements and re-tighten if necessary.

Page|2


DSE1376LYRev12/13
5) The antenna SWR has been adjusted at the factory for less than 1.5:1 VSWR.
Additional tweaking can be accomplished by changing the shape of the driven element slightly
and by adjusting the distance between the driven element and R1 and D1. R1 is the reflector
closest to the driven element. If you do not have a microwave return Loss Bridge or coupler,
leave it alone! The antenna will typically be better than -20 dB return loss right out of the box!
6) If antennas are to be stacked, see "Instructions for Stacking Loop Yagis".
Directive Systems Warranty Policy
All Directive Systems antennas are built with the finest materials available. We take great pride in building a
quality product that will give years of good service and performance. If there is a defect in materials or
workmanship within 90 days of purchase, Directive Systems will repair or replace, free of charge, the
defective part. DO NOT RETURN ANYTHING WITHOUT PRIOR AUTHORIZATION FROM DIRECTIVE
SYSTEMS. Please contact us either by phone or email describing the problem and we will work to resolve it.
If, after examining a new antenna you received, you are not satisfied, contact us immediately for return
authorization and refund. ANY ANTENNA THAT HAS BEEN MODIFIED WILL BE SUBJECT TO A
RESTOCKING CHARGE. IF AN ANTENNA IS SO MODIFIED AS TO MAKE IT UNUSABLE, DIRECTIVE
SYSTEMS RESERVES THE RIGHT TO REFUSE TO ACCEPT THE ANTENNA FOR RETURN.