Discount Car Stereo AUX-CH3 User manual

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
AUX-CH3
INSTALLATION GUIDE FOR CHRYSLER WITH EXTERNAL CD CHANGER OR SIRIUS RADIO*

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•Careless installation and operation can result in equipment damage.
Requirement
Working CD changer or Active Sirius subscription*
Introduction
Many older Chrysler owners seeking to add an aux input jack to their vehicles
without changing the radio, sacrificing the CD changer or compromising Sirius
radios subscription will be pleased to know the AUX-CH3 requires and retains
at least one of these options to provide a 3.5mm audio jack to which uses may
connect and play all kinds of audio devices including Smartphones, MP3 Players,
iPods etc.
Vehicles must have a separate CD changer or active Sirius subscription (one or
the other or both). If only Sirius radio is present, it must be active (not
expired) otherwise the AUX-CH3 will not work.
For more details, see Frequently Asked question at the end of this guide.
Installation
Radio removal required to gain access to 10-pin connector. (Vehicle specific
radio removal instructions are not part of this guide, but may be available
upon request)
1. With radio removed, disconnect factory 10-pin plug (See Fig. 1) from
radio (See Fig. 2)
Fig. 1
10-pin plug
Fig. 2
Radio connectors
2. Connect factory 10-pin plug (from step 1) to adapter 10-pin connector
(See Fig. 3)
Fig. 3
10-pin connector
3. Connect adapter 10-pin plug (See. Fig. 1) to radio 10-pin connector

4. Carefully route jack (See Fig. 4) to dash or nearby panel (within 4 ft.)
Location will vary based on vehicle and customer’s preference.
Fig. 4
5. Drill a ¼” hole to dash or panel, and secure with nut (See Fig. 5)
Fig. 5
WARNING: Should you decide on securing the jack, make sure the panel is
at least 1/8” thick for the threads on the jack to protrude and engage the
nut. (If necessary, use a dremel to grind or thin the panel) Drilling a hole
to secure the jack is not necessary but doing so makes for a stock look
and easier to plug/unplug audio device.
Operation
1. Turn radio “ON”
2. Press “MODE” button to enter Sirius or CD changer mode
For Sirius subscribers: Most recent Sirius channel will play.
For CD changer: At least one disc must be loaded in changer magazine
3. Connect audio device to 3.5mm jack using included 3 ft. audio cable or
similar (See Fig. 6).
4. Play song on audio device.
Fig. 6
audio cable
5. Use radio volume control button to set playback level. To reduce
distortion, we recommended setting audio device volume level to 80%
or less
WARNING: Playlist and Track selection is *NOT* possible from the
Chrysler Radio. Use the audio devices built-in controls to access audio
files.
6. To listen to Sirius radio or CD changer, simply disconnect the 3.5mm
audio cable from jack and operate Sirius or CD changer as customary
7. If correct operation is confirmed go ahead and reinstall the radio.

Frequently ask questions
1. Does the AUX-CH3 work in vehicles with a 6-CD changer radio
(changer built-into radio such as the RBQ)?
YES; BUT vehicle MUST also have an **External (remote) CD changer
or active *Sirius radio subscription. If vehicle does not have at least one
option, the AUX-CH3 will NOT work as described. See our auxiliary input
adapters (CHY02-AUX.)
2. My vehicle does NOT have an external CD changer and Sirius radio
subscription has expired; will this adapter still work?
NO;If vehicle does not have a CD changer and Sirius subscription has
expired, this cable WILL NOT WORK. Sirius radio subscription (active)
required for vehicles without CD changers.
3. My vehicle has both an external CD changer and active Sirius radio
subscription; do I need to disconnect anything for the AUX-CH3 to
work?
NO; the AUX-CH3 requires at least one factory option. The option could be
Sirius radio (With subscription), external CD changer or both
4. Factory radio (MY GIG) in my vehicle has Sirius built-in; will the AUX-
CH3 work?
NO; The AUX-CH3 is NOT compatible with Chrysler (MY GIG) radios with
built-in Sirius tuner (e.g., RES, REQ, REN and RER radio codes)
** External or remote CD changer refers to the optional CD installed in lower dash, center
armrest, hatch, trunk etc. (external CD changer is not the changer built-into head unit)
*Sirius radio subscription must be active (will not work if expired)
© 1995-15 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change
without notice. Other products and companies referred to herein are trademarks or registered trademarks
of their respective companies or mark holders.