Discount Car Stereo JAG-CD Instruction Manual

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
JAG-CD
QUICK START INSTALLATION GUIDE FOR JAGUAR X308 AND X100 WITH CD CHANGER
1997-99 Standard or Premium Audio System & 2000-06 Standard Audio System
(NOT for 2000-Up Premium Audio System)
Created May 3, 2016
Revised: September 11, 2021

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
Careless installation and operation can result in equipment damage
Requirements
CD auto changer
Introduction
Those Jaguar owners who are adamant about hanging on to the original radio
and audio system we offer a line of adapters that sure to open up a whole lot of
different options for listening to music and other audio content. The JAG-CD
adapter provides a 3.5mm Audio jack which can be used to connect and play all
kinds of audio devices including Smartphones, MP3 Players, iPods, Zune, iPads
etc. The JAG-CD auxiliary input adapter does not control or charge audio device
and connects to the back of the radio in late 1997-99 XJ (X308) and XK (X100)
Standard OR Premium Audio Systems and 2000-03 XJ (X308) and 2000-
06 XK (X100) Standard Audio Systems only. See Frequently Asked
questions at the end of this guide for more details.
Installation
Warning: The JAG-CD connects to the radio (not to Changer) and radio removal is
required. All 2000-03 x308 and 2000-06 x100 premium sound system (amplifier)
requires the JAG-CDR
This step may not be necessary but we recommend disconnecting the
Negative Battery Terminal (See Fig. 1)
Fig. 1
1. Move “J” gate selector to position “D”
2. Using a panel removal tool, unclip and remove “J” gate finisher (See
Fig. 2)
Fig. 2
3. Using a T30 torx head, remove “J” gate finisher plate (See Fig. 3)
Fig. 3

4. Lift finisher plate upwards and disconnect electrical plugs (See Fig. 4)
Fig. 4
5. Remove center console veneer panel (See Fig. 5)
Fig. 5
6. Remove (2) Philips head screws on LH and RH side of console (See Fig.
6)
Fig. 6
7. Lift radio over gear selector hub and remove from dash (See Fig. 7).
Fig. 7
8. Disconnect CD changer plug from radio as seen in Fig. 8
Fig.8
9. Connect CD changer male plug (from step 8) into female connector on
the adapter box. (See Fig. 9)

Fig. 9
Adapter connections
Warning: Single DIN radios (e.g. LJB4100BA) most XK vehicles
the radio ground strap (See Fig. 9a) may need to be relocated. This
applies only to single DIN radios in non-premium vehicles with ground
strap.
Fig. 9a
10. Connect adapter male plug to radio CD port (don’t force, twist or
wiggle)
11. Carefully route audio jack (See Fig. 10) to front of dashboard or nearby
location to be mounted (within 4 ft.). Mounting location will vary based
on vehicle and customer’s preference.
Fig. 10
Audio Jack
12. Drill a ¼” (6.35mm) hole at chosen location and secure jack to dash
with nut (See Fig.11)
Fig. 11
Warning: Should you decide to mount audio jack, make sure mounting panel
is no thicker than 1/8” for jack shaft to engage with nut. (If necessary, use
a Dremel or sander to thin panel). Mounting audio jack is not necessary but
doing so makes for a stock appearance and easier to connect and
disconnect your audio devices.

Operation
1. Turn radio ON.
2. Press “CD” button. Track/Disc number will be displayed only if there is
a disc in magazine otherwise “NO MAGAZINE” is displayed (See Fig. 12)
Fig. 12
3. Connect audio device to 3.5mm jack using Free 3 ft. Audio cable (See
Fig. 12).
Fig. 12
3.5mm male to male cable
4. Place audio device in playback mode. This interrupts CD changer
Playback and music from Audio device will play on car speakers.
5. Use radio volume control button to set playback level and audio device
volume setting to match CD or radio playback levels.
6.
Warning: Song display, playlist and Track selection is *NOT* possible
from radio. Must use audio devices built-in controls to access audio
files.
7. To listen to the CD changer, simply disconnect the 3.5mm audio
cable from the jack and operate changer as customary (Jack must be
empty during CD changer playback otherwise playback may include
noise or buzz)
8. If correct operation is confirmed go ahead and reinstall radio

Frequent ask question
1. Does the JAG-CD work in Premium Systems?
YES; works in late 1997-99 XK (X100) and 1998-99 XJ (X308) Premium
Audio, NOT compatible with 2000-06 XK (X100) nor 2000-03 XJ (X308)
Premium Sound Systems. These require the JAG-CDR. In other words,
the JAG-CD is not compatible with 2000-Up with Premium Audio.
2. How do I know if vehicle has a Premium Sound System?
- Premium Sound System has an amplifier mounted atop audio rack in
trunk: To check simply remove driver side carpet panels to reveal audio
rack. (See picture below).
-If vehicle has subwoofer mounted to rear deck (Sedan) or rear side
panels (convertible), this also indicates vehicle has amplifier.
3. Can I contact DiscountCarStereo.com to find out which sound system
is present in my vehicle?
Unfortunately we will not be able to tell your sound system. See question #2
to determine sound system prior to purchasing these parts.
4. What’s the difference between your JAG-CD and JAG-CDR?
The JAG-CDR connects to CD changer in trunk/hatch and works in both
premium and standard Audio Systems. The JAG-CD connects to the radio
and compatible with 1997-99 XK (X100) and XJ (X308) Standard or
Premium audio systems and also work in 2000-03 XJ (X308) and 2000-06
XK (X100) Standard Audio Systems only. (Not for 2000+ Premium
Systems)
5. Can I install the JAG-CD without removing the radio?
NO;the JAG-CD must be connected to radio.
6. In which model/years will the JAG-CD work and where does it connect?
The JAG-CD is specific to the following vehicles and connects to the radio
(Not to CD plug in trunk/hatch)
1998-99 XJ (X308) Premium System- connects to radio
1998-03 XJ (X308) Standard Sound System- connects to radio
1997*-99 XK (X100) Premium Sound System—connects to radio
1997*-06 XK (X100) Standard Sound System—connects to radio
Warning: 2000-03 x308 and 2000-06 x100 Premium Sound systems
requires the JAG-CDR (which connects only to Changer in trunk)
7. Will I be able to connect the JAG-CD to the CD Changer instead of the
radio?
NO; The JAG-CD connects to the radio and will not work if connected to CD
Changer plug. 2000-Up Premium system requires the JAG-CDR.
*Late 1997 with Ai-net plug (not for early 1997 with 8-pin plug)
Disclaimer
• This product has no affiliation with Jaguar or Apple
• There are no warranties expressed or implied by purchase of this product
• We’re not liable for misuse of this product.
Email [e-mail]
© 1995-Sep-21 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change
without notice. Other products and companies referred to herein are trademarks or registered trademarks of their
respective companies or mark holders.