Discovery Telecom 80255 User manual

WARRANTY
Replacement Parts & Limited Lifetime Warranty
Discovery World Furniture will replace any component part free of charge for 1 full year via UPS freight collect. In
addition, Discovery World Furniture will replace any component part for 50% of the then prevailing retail price plus
freight for the lifetime of the product. For service, mail your request to:
Discovery World Furniture 2963 Stonewall Place, Sanford, FI 32773
80255
5 Drawer Chest
Discovery
World Furniture
TM
Tool required (Not included)
Phillips screw driver
G01
H01
Allen bit
3,5x16mm
10
A
B
C
D
E
08
7,0x50mm
16
60
06
F12
8x30mm
M4x25mm

B
F
E
2
3
B
B
B
F
E
F
E
F
E
9
10
11
12
4
5
6
7
8
1
2
3
(5x)
1
Parts List

3
2
F
E
F
E
B
5
4
6
7
B
B
B
BBB
B
B
B
B
B
F
A+G
A+G
A+G
A+G
A+G
A+G
4
5
6
2
3
7
A+G
F
F

F
F
F
1
C
D
C
C
C
C
9
10
8
11
12
C
C
C
C
C
C
D
C
5
4
(5x)

!WARNING
Children have died from
furniture tip-over.To reduce the risk
of furniture tip-over:
ALWAYS Install tip-over restraint
provided.
NEVER put a TV on this product.
NEVER allow children to stand, climb
or hang on drawers, doors, or shelves.
NEVER open more than one drawer
at a time.
Place heaviest items in the lowest
drawers.
This is a permanent label.
Do not remove!
TV
6

Anti-Tip kit Instruction
Discovery
World Furniture
TM
Tipping furniture can injure young children. Use of this safety bracket hardware is highly recommended. This safety hardware,
when properly installed can provide further protection against unexpected accidental tipping of furniture due to improper use.
Tool required- Screw driver
PO#___________________ Date:_______________
Step 1 Step 2 Step 3
- Attach the second metal clip (L) to the wall anchor (J)
(If you can not use a wall stud) and screw (I) as a shown.
Parts List
I J
KLM
Make sure the brackets are firmly attached to the wall stud, the furniture frame and the safety strap is snug.
This product is not to be a substitute for proper parental supervision which is the only proper deterrent to
prevent improper use of this unit.
The manufacturer assumes no liability for improper installation or excessive loads placed on the safety
straps, bracket or mounting screws.
This hardware will not insure against tipping.
For taller or heavier pieces of furniture, two safety brackets may be installed.
Important warning
Furniture
ML
- Determine the location of your furniture. Find the
center of the back edge of the top of your furniture,
and once determined, mark it. Make a matching
mark on the wall. Attach the metal clip (L) exactly
as shown in the diagram using screw (M).
Wall I
J
L
LL
K
recommended to place all heavier items on the
lower drawers of the furniture.
- Once the clips are secure and tight, place the
furniture with clips as close to the wall with clip.
Then attach the cable tie (K) as shown, making
sure it ‘locks’ and pulls together. If you wish,
you can cut the top end of the tie to conceal
As an additional safety measure, it is
this hardware.
Furniture
Wall