three h GREET User manual

GREET
L Shape + Cap

Phillips Screwdriver Robertson Screwdriver
Titus Connector VB ConnectorTitus Pin
Mending Plate
VB Pin MiniFix MiniFix Connector Fast Cap Screw Uro Screw
• Product that is damaged by the end user due to misuse, accident, abuse,
negligence or shipping is not covered under Three H warranty.
• Use tools and hardware mentioned above to avoid any product faults.
• It is best to assemble our furniture with 2 or more persons.
• If you believe you are missing pieces, please contact [e-mail]
DISCLAIMERS!
INCLUDED HARDWARE
REQUIRED TOOLS
Hardware & tools required may vary depending on the Greet™ specifics.
The following instructions do not specify the amount of hardware included.
Due to variations in design, a separate hardware list will be provided.
GETTING STARTED
Assemble on a soft surface to avoid scratching the laminate.

STEP 1
STEP 2
STEP 3
Main Desk - Leg Installation
Position the Pedestal
Main Desk - Top Installation
Rest the Modesty on the provided spacers.
Align the Titus pins on the legs to the pre-
drilled holes on the modesty.
Fasten the Titus Connectors with a Phillips
screwdriver.
Align the door fronts to the leg.
Use a level to ensure the worksurface
will lay properly.
Remove the two top drawers.
Lower the top onto the Titus & VB Pins.
Fasten the worksurface using a Phillips
screwdriver on the Titus Connectors and
VB Connectors.

STEP 4
STEP 5
STEP 6
Pedestal Installation
Main Desk - Upright Installation
Main Desk - Riser Top Installation
Remove the two top drawers of the
pedestal. Use 2 Panhead Screws and a
Phillips screwdriver.
Slide the drawers back onto the glides.
Slide the 2nd uprights into place.
Fasten the Titus Connectors with a
Phillips screwdriver.
Lower the top onto the Titus Pins.
Fasten the Titus Connectors with a
Phillips screwdriver.

STEP 7
Return Desk - Leg Installation
Slide the leg Titus Pins into the
modesty pre-drilled holes.
Fasten the Titus Connectors using a
Phillips screwdriver.
STEP 8
Return Desk - Top Installation
Lower the top onto the Titus Pins.
Fasten the Titus Connectors using a
Phillips Screwdriver
STEP 9
Combine the Desks
Push the desks together and level them
out. Swing the Mending plates over top
of the pre-drilled holes.
Fasten using Uro Screws.

STEP 10
STEP 11
STEP 12
Greet Cap - Modesty
The Cap is built with MiniFix Pins which
need to be fastened into brass dowels
using a Phillips screwdriver.
Greet Cap - Upright Installation
Slide the Uprights onto the MiniFix
Pins Fasten using the MiniFix Con-
nectors and a Phillips screwdriver.
Greet Cap - Top Installation
Insert the MiniFix pins into the Top
and place into the predrilled holes in
the uprights.
Fasten using the MiniFix Connectors
and Phillips screwdriver.

STEP 13
STEP 14
Finishing Touches
Greet Cap - Position
Greet Cap - Fasten
Cover the visible connectors with the provided Fast Caps. Try to grain match for the best appearance.
Adjust the levelers as needed.
Place the Cap and align the pre-drilled
holes from the Desk to the Cap.
Fasten using FastCap Screws and a
Robertson screwdriver from under
the desk.

Need Help?
[e-mail] | 1.800.767.5374
June 20, 2018
Revision No.1