Displays2go LECTFACVFC User manual

LECTFACVFC
AssemblyInstructions

LecternParts:
1. Reading Top
2. Base
3. Body
4. Pre-Installed Shelf
Hardware:
5. (8)Flat HeadScrews
6.PhilipsHeadScrewdriver(Not shown)
1.ReadingTop
4. Pre-Installed Shelf
2. Base
5. FlatHead Screws(4)
3. Body
5. FlatHead Screws(4)

Attaching theBase tothe Body
Figure 2
1. Position the Base and Bodyon a clean flat surface.
2. Align the pre-drilled holesin the Bodywith the threaded
insertsin the Base.
3. Using the provided Screwdriver, attach the Bodyto the
Base with (4)Flat Head Screwsasillustrated in Figure 2
Tip: Do not fully tighten these screwsuntil the unit
is otherwise fullly assembled.
Attaching theReading Top
1. Position the Reading Top overthe Bodyasillustrated
in Figure 3.
2. Align the pre-drilled holesin the Bodywith the threaded
insertsin the Reading Top.
3. Using the provided Screwdriver, attach the Reading Top
to the Bodywith (4)Flat Head Screwsasillustrated
in Figure 3.
Tip: You should nowfully tighen all (8)Flat Head Screws.
Figure 3