Displays2go CLEDSN Series User manual

AssemblyAssembly
InstructionsInstructions
SKUs: CLEDSN SeriesSKUs: CLEDSN Series
CRYSTAL LEDCRYSTAL LED
LIGHT BOXLIGHT BOX
SIDEWALKSIDEWALK
SIGNSIGN

2
PARTS LIST
If you have any questions regarding our products, please visit us at www.displays2go.com or
contact Displays2go customer service at 844-221-3388.
Scan QR code
to visit product
page
Signage ships fully assembled, as shown at left.
NOT PICTURED: Power supply cable (1).
NOTE: Graphic not included.
NOTE: Wingnut screws (pictured
above) are removable and are
composed of three pieces, as shown.
QUANTITY: 4
(Attached to unit)
REMOTE DETAILS:
Top Row (L-R): Increase Brightness,
Decrease Brightness, Play, Power On/Off
Function Buttons: Flash (blinking lights),
Strobe (multicolor rapid flashing), Fade
(transitions between colors), Smooth (tri-
color blinking)
Bottom Section: Allows for customization.
Press “DIY” button, then use arrows to set
desired light pattern.
NOTE: Remote controls ONLY LED lights on the side of the unit.
Poster backlight can be controlled by unpluggging to turn off.

3
3. Screw wingnuts tightly back into unit to secure graphic.
4. Stand unit upright. Connect cable to on-unit wire; this
controls the LED lights on unit.
1. Lay unit down on a soft surface.
Carefully unscrew wingnut bolts to
remove top glass panel. Adjust unit as
needed to access screws.
NOTE: Wingnuts are three pieces.
2. Lay graphic onto the signage.
Ensure that the graphic is straight and
as desired.
Eny r wEny r w
iew i!iew i!
CONTACT INFORMATION:
www.displays2go.com
PHONE: [phone]
5. Plug cable into an electrical outlet. Use remote to turn on
LED lights; change light colors as desired using remote.