Dive Rite BC1063 User manual

Dive Rite
Basic Harness
Item # BC1063
This harness utilizes nylon webbing
for strength and comfort.
It also features tubular webbing
sleeves to minimize wear wherever
the harness would normally be in
contact with a metal backplate.
Packaging contains:
1) 11 ft of 2” harness webbing,
with stainless-steel grommet
2) 2 tubular sleeves (4” each)
3) 2 tubular sleeves (5" each)
4) 4 Stainless-steel Belt Slides
5) 2 Stainless-steel D-rings
6) 2 Stainless-steel bent D-rings
7) 1 Stainless-steel waist-strap
release buckle
This Dive Rite Harness fits on
all Dive Rite backplates.
Great for technical diving,
where simplicity is
the key!
* * Crotch Strap not included * *
© 2015, Lamartek, Inc. dba Dive Rite
175 NW Washington Street
Lake City, FL 32055 USA
www.diverite.com
v1.0

Threading Basic Harness
Shoulder Strap Routing
© 201100 Lammaartekk,, Inc.. dbaa Divee Ritte
www.diverite.com
v1.0
1) Begin by threading 2 tubular sleeves onto the harness
webbing. These will end up where the harness goes through
the upper shoulder strap slots, as shown in figure A.
2) Thread the harness webbing through the upper shoulder
strap slots (figure A), positioning the webbing so the grommet
is over the upper tank bolt hole on the plate.
3) Thread the remaining 2 tubular sleeves onto the harness
webbing, ending up where the harness goes through the
waist slots, as shown in figure C.
4) Install one 2” belt-slide and one 2” bend D-ring on each
side of the webbing, as shown in figure B.
5) Then thread one tail of the webbing though the waist slot
(back through the inner slot, then forward through the outer
slot). Repeat this step for the opposite tail (see figure C).
6) Again install one 2” belt-slide and one 2” D-ring on each
side of the webbing, as shown in figure B.
7) Locate and install crotch strap. Refer to Figure D.
8) Using same side as the crotch strap loop, install waist
strap release buckle using slots on buckle.
A
TOP
BACK
B
STEP
 4

STEP
6
FRONT
C
Waist Strap
Routing
D