DIVEX X-Propeller Instruction Manual

Installing X-Propeller Manual
www.dive-xtras.com
4433 Russell Rd, STE 106
Mukilteo,WA 98275 USA
Tel: [phone]
Fax: [phone]
Parts included in with your new propeller:
Propeller (assembled)
Loctite 243
.125” diameter 1” long dowel pin
M5x35 Screw
Retaining Ring
Spring Cap
Clean shaft if needed. Install included standard
dowel pin into shaft. (Retaining ring shown)
Remove your existing propeller down to the retain-
ing ring. If you have a retaining sleeve, you will
need to remove the sleeve and the collar. Install the
spring cap and retaining ring provided. (Retaining
Ring shown).

Installing X-Propeller Manual
www.dive-xtras.com
4433 Russell Rd, STE 106
Mukilteo,WA 98275 USA
Tel: [phone]
Fax: [phone]
Place the X-Propeller onto the shaft. Line up the
dowel pin and the X-Propellers insert for proper
installation.
(e oat plate should be able to move around in its
pocket with your nger. If you cannot move it with
one nger, loosen screws until you can. )
Install propeller screw to secure the X-Propeller.
Apply ample amount of Locktite to secure the
screw to the motor shaft.
WARNING: DO NOT OVER TIGHTEN
Tighten screw till it is snug, then give it an addi-
tional quarter turn. Over tightening the screw can
result in unwanted rubbing on the tail.