DIY CREW PAPER ROLL CUTTER User manual

PAPER
ROLL
CUTTER
Metal Triangle Based (2 PCS)
Packing List
Spring Arm (2 PCS)
Wooden Dowel (1 PIECE)
Metal Blade (1 PIECE)
Metal Rod (2 PCS)
Wall Anchor
(6 PCS) Wall Screw
(6 PCS) Metal Screw #1
(6 PCS)
Small Screw #2
(4 PCS)
Rubber Feet
(6 PCS)

NOTE: Please contact us if there are missing pieces [e-mail]
STEP 3
STEP 1
STEP 2
Assembly instruction
Use 2 small screws (#2) and a
screwdriver to adjust them.
Check if the dowel ts in place
and install the paper roll
Use 4 screws (#1) and a
screwdriver to connect them.
Connect the metal rods to the base
Connect the blade to the arms
Put the dowel in place
Note:
The blade’s tab should be inserted
inside the arm’s slot. The cutting
edge should face the table

Troubleshooting
The most common reason for uneven cuts is the blade not being installed correctly.
Make sure the blade tabs are inserted inside the arm’s slots. This will ensure the blade
stays in the right position and prevents bending.
What to do if paper is not getting cut properly?
Is the blade bending?
How to cut the paper?
Where should the blade face?
How to install the paper?
This means the blade is not properly installed. Please check the 2 previous questions
to get more information about this issue.
The blade’s cutting edge should be facing down looknig at the table (or the wall for
wall-mounted units)
The paper should be installed the correct way for the product to function ( with the
loose end wraped around the top)
Feed the paper under the blade. When you are ready to make the cut, pull the paper
in an upward and energic movement
Do you need more help?
If your issue in not listed above please send us a message/email with your questions.
Our team replies in less than 48hs. We will be happy to help you with any issue. A
more detailed assembly video is available upon request and will be uploaded soon
to our website and all online marketplaces (Amazon, Walmart, Target)