DMP Electronics EBOX-ALN3350 User manual

EBOX-ALN3350/ALJ3455SeriesMiniPC
User’s Guide

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 2
Copyright
This manual is subject to change without notice for continuous improvement in the product.
All rights are reserved. Manufacturer assumes no responsibility for any inaccuracies that may contain
in this document, and makes no commitment to update or keep current information in this manual.
No part of this manual may be reproduced, copied, translated or transmitted, in whole, in part,
or in any form or by any means without the prior written permission of the DMP Electronics Inc.
Copyright 2021 DMP Electronics Inc.
Trademarks Acknowledgment
Intel® Apollo Lake is the registered trademark of Intel Corporation.
is the registered trademarks of DMP Electronics Inc.
Other brand names, product names or trade names appearing in this document are the properties
and registered trademarks of their respective owners. All names mentioned herewith are served for
identification purpose only.
Safety Information
WARNING
Do not expose EBOX torain or moisture, in orderto prevent shockand fire hazard.
Never install EBOX in wet locations.
Do not open cabinet to avoid electrical shock. Refer to the nearest dealer for qualified personnel servicing.
Never touch un-insulated terminals or wireunless power adaptor and display monitor are disconnected.
Locate EBOX as close as possible to the socket outline for easy access and to avoid force caused by
entanglingof your arms with surrounding cables from the EBOX.
When using EBOX, avoid using or installing the modem to the serial port during a storm or a lightning.
Do not use the modem or a telephone to report a gas leak in the vicinity of the leak.
USB connectors are supplied with Limited Power Sources.
DO NOT ATTEMPT TO OPEN OR TO DISASSEMBLE THE CHASSIS (ENCASING)
OF THIS PRODUCT. PLEASE CONTACT YOUR NEAREST DEALER
FOR SERVICING FROM QUALIFIED TECHNICIAN.

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 3
Regulatory
FCC Class A Note
This equipmenthas beentested and found to comply with the limits for a Class Adigital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, ifnot installed and used in accordance with instruction manual,
may cause harmful interference in which case user will be required to correct interference at his own expense.
Testingwasdone with shielded cables. Follow FCC regulations, user must useshielded cables with installation.
WARNING
This product complies withEN55032 class A.Ina domesticenvironment, it may causeradio interference
in which case theuser may be required totake adequate measures.
Changes or modificationsto this unit not expressly approved by the party responsible for compliance could void
user’s authority to operate the equipment.
This device complieswith Part15 ofthe FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
includinginterference that may cause undesired operation.
This digital apparatus does not exceed Class A limits for radio noise emissions from digitalapparatus as set out in
interference - causing equipment standard “Digital Apparatus”, ICES-003of theDepartment ofCommunications.
Manufacturer’s Declaration of Conformity
This equipment has been tested and found to comply with the requirementsof European Community Council
Directives2014/30/EU & 2014/35/EU relating to electromagnetic compatibility and product safety respectively.
Attention
This product hasbeen designed and certified to comply with certain regulatory requirementspertaining to
Information Technology Equipment. This product has not been designed for use as a medicaldevice.
Withoutlimitation ofthe foregoing,thisproduct isnot intendedandhasnot beencertifiedforusein a hospital
or clinical environment to diagnose, treat, or monitor patients under medical supervision, and is not intended
and has not been certified to make physical or electrical contact with patients, nor to transfer energy to or from
patients and/or to detect such energy transferto or frompatients.

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 4
Purchase Agreement
Purpose:
In accordance to the general commercial conduct of Trust and Fair Trade, herewith below isthe agreement
for the protection for both parties, DMP and Users in pursuant of trading.
Product Description:
Fanless PC with an Intel® Apollo Lake N3350 Dualcore or a J3455 Quad core processor.
Supports memoryup to 8GBDDR3L, Multi-Display outputs, Multi-COM functions, and Dual Giga LAN.
Perfectplatform forM2M, Industry4.0, HomeAutomation,Security, Point-of-sales andmanymore.
Distribution Convention:
1. This Productincludesa PCandapowersupply unit. Uponreceivingthisproduct,pleasereferuser manual,
check for contents and appearance of this product, contact nearest dealer orDMP office for any defective
or missing partsimmediately. Supplier will not be responsible for any reported discrepancy there after
the expiration period of 3-days from the received date.
2. In consideration of transportation and the costof storage, the supplierprovides tothe distributors
a warranty of 12 months. This warranty covers the failure causedby hardware breakdown
(excluding hard drives), butdoes not cover the actof misuse and mishandling.
3. The supplier will not accept unknown post, therefore if you wish to repairorto return your goods,
please contact nearest dealer to make your declaration, and at the same time, apply for an RMA number
(RMA stands for Return Merchandise Authorization –please ask for RMAform and fill-up for authorization).
4. The freight for return goods for repair will follow the International customary practice and convention.
Both parties is to pay for freight of one shipment each.Shipper is required to prepay the freight
from the place of origin (This means that the returnee/usercovers the freightfor return goods,
while theSupplier coversthefreightfor goodsafter therepair).
5. Obsolete warranty is referred to as: (1)Expiration of warranty or (2)Damage due to misuse within warranty.
Supplier will betaken into consideration of the circumstances, to provide repair service
with charges expense for obsolete warranty. This expense includesmaterial costs and the cost oflabor.
Note: If there is other particularissue, not listed in the above conditions, both parties agreed to follow
GeneralLawof Commerce with fair and reasonable discussion in handling andresolving the argument.

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 5
Contents
Chapter1
07 Unpacking EBOXMini PC
Chapter2
10 Overview
11 Internaldescription
12 Appearance Diagram
13 System Specifications
14 Peripherals
Chapter3
17 BIOS Reconfiguring
17 LoadDefault Setting
18 COM Setting (RS-232/485/422)
20 GPIO Setting
21 AT Mode Setting (Auto Power On Function)
22 Serial Port Console Redirection
22 OS Selection
24 PXE diskless boot Selection
25 Drivers Installation Guide
25 Chipset driver
26 Graphic driver
27 Audio driver
28 LAN driver
29 TXE driver
30 iRMT driver
31 ISH driver
Chapter4
33 Onboard Connectors Summary
34 Pin Assignments
Chapter5
39 Taking Careof EBOX
41 Troubleshooting
Chapter6
43 Terms andCondition
43 Warranty
43 Service andSupport
43 Return Merchandise Authorization (RMA) Policy
43 ShippingPolicy

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 6
Chapter1

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 7
Unpacking EBOX Mini PC
Component List:
Item No.
Description
Quantity
1
EBOX-ALN3350/ALJ3455SeriesMiniPC
x1
2
Power Adaptor40W; Vin:100~240V AC 50~60Hz
x1
3
Power cable (AvailableUS, UK, EU, AUtypes)
x1
4
VESA screw
x4
Note: The accessories are subject to change without immediate notice.
Check before Use
1. EBOX-ALN3350/ALJ3455 Series Unit 2.Power adapter 40W
3. Power cable 4. VESA screws

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 8
Preface
EBOX-ALN3350/ALJ3455 Series Mini PC
Fanless PC withan Intel® ApolloLake N3350 Dual coreand a J3455 Quadcore processor.
Supports memoryup to 8GB DDR3L,Multi-Displayoutputs, Multi-COM functions, and Dual Giga LAN.
Perfect platform for IoT, M2M, Industry 4.0, Home Automation Security, Point-of-sales, andmany more.
EBOX-ALN3350/ALJ3455 Series can be attached to any VESA mounting fixture; allowing to be securely mounted
onto desks, walls, or buildings, and thereby optimizes your work area. It can also attach directly to any size LCD
for a trade shows, presentations, promotions, etc. With FANLESS design, it’s ideal to be used in the environment
where temperature demand iscritical.
This Seriessupports Windows 10, Windows 10 IoT and Linux OS that meet ready-to-market demand
and provide competitive advantagesfor customers.

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 9
Chapter2

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 10
EBOX-ALN3350/ALJ3455 Series Overview
I
I
J
K
B
A
B
C
D
E
J
L
F
G
A
B
C
B
D
D
E
E
Front Panel
A: VGA port
Support VGA display
B: USB 3.0 port
Connection for external USB devices
C: D-Sub 9-pin connector (w/COM)
Connection for RS-232/485/422 interface devices
Refer page 18, 19 for setting instruction
D: Power LED
LED lights up when the system is turned on
E: Power Button
For system power on/off
F: D-Sub 9-pin connector (w/8-bit GPIO)
Connection for GPIO applications
G: D-Sub 9-pin connector (w/COM & 8-bit GPIO)
Connection for GPIO applications
Back Panel
I: RJ-45 LAN Jack
Realtek 8111H GigaLAN
J: HDMI Output port
Support HDMI display
K: Mic in/Line out phone jack
Realtek ALC662VD Mic in/Line out combo jack
L: Power Jack
DC +12V~+16V

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 11
Internal description
Optional item MINIPCIE-WLAN-161H WiFi/BT module info www.compactpc.com.tw

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 12
Appearance Diagram

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 13
Order information

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 14
Peripherals
Connecting the Power Adaptor
A: DC power Jack
+12V/3.33A AC adapter with power cable
is used for the power source
Connecting the Monitor
B: VGA Connection
Connecting VGA display via VGA cable
C: HDMI Connection
Connect HDMI display via HDMI cable
A
B
C
C

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 15
Peripherals
Connecting Input & Output ports
EBOX-ALN3350/ALJ3455Seriesprovide4 external USBports(2 atfront,2 atrear).
D: USB 3.0 port
Connection for external USB devices
(supports up to 5Gbps data transfer rate)
E:D-Sub9-pinconnector(w/COM)
Connection for RS-232/485/422 interface devices
F: Power LED
Power LED lights up when the system turned on
G: D-Sub 9-pinconnector(w/8-bit GPIO)
Connection for 8-bit GPIO applications
H: D-Sub 9-pin connector (w/COM& 8-bit GPIO)
Connection for 8-bit GPIO applications
I: RJ-45 LAN
RJ-45 LAN jack for Ethernet connection
J: Microphone/Earphone
Functions as audio Lineoutand Mic in
G
I
D
D
D
E
D
F
J
H
E
F
F
D

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 16
Chapter3

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 17
BIOS Reconfiguring
Load Default Setting
1. To reconfigure the hardware, press <Esc> key to enter BIOS setup main menu.
2. Press “F3” key to load optimized defaults as below:
3. After setting, press “F4” key to save & exit.

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 18
Hot key
Press <F7> after boot up, a select menu will appear. Use direction key to select boot device.
BIOS COM Setting (RS-232/485/422)
1. Press <Esc> during boot up, enter BIOS menu, move to “Advanced” for “Super IO Configuration”.

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 19
2. Move to “Serial Port 1 Configuration”.
3. Next to Transmission Mode and select COM port Mode.
4. Press “F4” key to save & exit.

EBOX-ALN3350/ALJ3455 Series User Manual
DMP Electronics Inc. 20
GPIO Setting
Press <Tab> and move to “Advanced” for “Digital IO Configuration”.
Remark:
DIO Port 7 (SIO_GPIO26) is Strapping Pin, when switch to output mode will became Push pull mode.
In addition, the voltage at the output is different than general GPIO Ports, see below:
Port 1, 2, 3, 4, 5, 6, 8 -> Output: Low: 0V
Port 1, 2, 3, 4, 5, 6, 8 -> Output: High: 5V
Port 7 -> Output: Low: 0V
Port 7 -> Output: High: 3.1V