Dogtra RR Deluxe Service manual

Copyright c 2008 Dogtra Company
22912 Lockness Avenue
Torrance, CA 90501
U.S.A.
telephone (310) 534 - 0101
fax (310) 534 - 9111
toll free 1-888-811-9111
2008 -
CODE SETTING GUIDE
www.dogtra.com

2
Code setting method to pair a transmitter with
receivers
uses code free technology so
that you can match one transmitter up to eight
different receivers. (16 including left and right
ports) Once the code has been set, pressing a button
on the specific selection dial will only activate the
designated receiver. Follow the steps in order to pair
a transmitter with a receiver unit.
1) Turn the selection dial of
handheld transmitter to the
desired number to pair it
with the receiver.(For
example, if you want to
designate a receiver as
your number 2 receiver, set
the selection dial of the
transmitter to number 2.)
2) Hold down the on/off
button of the receiver for 5
seconds or more. Release
them when the green LED
blinks rapidly.
3
3) Within 5 seconds after
releasing the on/off button
of the receiver, hold the
left and right buttons
simultaneously on the
handheld transmitter.
When the receiver
successfully
acknowledges the transmitter, the LED on the
receiver should emit a constant green light for
approximately 3 seconds then switch to slow
steady standby blink.
4) Press the duck call or beep sound button on the
transmitter. If the receiver emits sound, the
receiver is successfully coded to the transmitter.
(Repeat the process from step 1, if you have
additional receivers to be coded.)
CODE SETTING GUIDE CODE SETTING GUIDE