Dolphin 8092-30 User manual

Model#: 8092-30
Before starting your installation, please take a few
minutes to READ THESE INSTRUCTIONS CAREFULLY.
In addition, please check the product CAREFULLY for any
visible damage.
USE AND CARE GUIDE
Page 1 of 5

PRE-ASSEMBLY
VANITY AND COUNTERTOP
Model#: 8092-30
Before starting your installation, please take a few
minutes to READ THESE INSTRUCTIONS CAREFULLY.
In addition, please check the product CAREFULLY for any
visible damage.
USE AND CARE GUIDE
Page 2 of 5
A
B
Part Description Quantity
A 1Sink top
1B Vanity body

TOOLS REQUIRED
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size.
NOTE: Tools shown are not included.
AA x 6 BB x 3
Model#: 8092-30
Before starting your installation, please take a few
minutes to READ THESE INSTRUCTIONS CAREFULLY.
In addition, please check the product CAREFULLY for any
visible damage.
USE AND CARE GUIDE
Page 3 of 5
Part Description Quantity
AA 6Screws
3Door handleBB
Phillips
screwdriver
Silicone
sealant

Model#: 8092-30
Before starting your installation, please take a few
minutes to READ THESE INSTRUCTIONS CAREFULLY.
In addition, please check the product CAREFULLY for any
visible damage.
USE AND CARE GUIDE
Page 4 of 5
1Decide exactly where you wish to install your vanity and
gently put it down on the floor.
2
BB
AA
34
Take out the handles (BB) from the hardware bag,
and install all the handles on the front of the drawers.
Apply a small bead of silicone around the top perimeter
of the vanity body (B).
B
Carefully place the sink top (A) on the top of the
vanity body (B). Wipe away any excess silicone
A
B

CARE AND MAINTENANCE
To protect your bath furniture, we suggest the following:
□
□
Avoid placing your furniture in direct sunlight, as sunlight causes fading.
Clean up spills immediately. Use a blotting rather than a wiping action. Water left over a long period of time will cause
white spots in the finish.
Alcohol, perfume, aftr-shave and medications can cause severe finish damage.
For best results in cleaning and polishing your bath furniture, we recommend the following:
□
□
Dust frequently with a clean, soft, dry, lint-free cloth. Clean the surface by rubbing in the direction of the grain.
Polish your furniture approximately every six months with a product that contains detergents, emulsifiers and mineral oil.
The detergents clean dirt from the furniture; The emulsifiers give it body to clean and last longer; The mineral oil is left
behind as barrier for dirt and moisture that can harm the finish. There is no grit to harm the finish, no wax build-up, and
no silicone to raise the sheen and act as a barrier for touch-ups and refinishing.
Clean the outside surface with mild soap, warm water, and a soft cloth.
On stubborn stains, use a powdered detergent and damp sponge or nylon scouring pad.
Never use abrasive scouring powders, cleansers, or pads because they will scratch, damage, and dull the surface.
□
□
□
Model#: 8092-30
Before starting your installation, please take a few
minutes to READ THESE INSTRUCTIONS CAREFULLY.
In addition, please check the product CAREFULLY for any
visible damage.
USE AND CARE GUIDE
Page 5 of 5