DORANI Touch Instruction Manual

Wi-Fi App Connection Guide
Please See Dorani Touch Installation Manual for Wiring and Installation
The Monitor MUST be installed in a location with GOOD Wi-Fi signal
Low Wi-Fi signal can cause poor or unstable connections.
Locate the monitor as close to the Wi-Fi router/modem as possible
A Speed of 1.5Mbps UPLOAD is recommended AT THE MONITOR,
lower speeds may affect quality and reliability.
THE MONITOR WILL TAKE APPROXIMATELY 2 MNINUTES TO POWER UP
Step 2 –Connect to the local Wi-Fi / Internet ( ON THE MONITOR)
1 - Tap the Screen to reveal ALL Icons as below
Step 3 –Mobile APP connection ( ON YOUR PHONE OR TABLET)
1 : Open the APP 2 : Open Wireless settings on the monitor 3: Confirm
Press the PC button (see step 2 picture)
Scan the QR code on the screen with
your phone.
IOS - Save
Press the ‘scan’ button. Android –scroll to bottom of screen and SAVE Device should now be registered
**You can access the assistant by pressing the MENU button 4 lines top right of screen) followed by Assistant**
PC Wi-Fi
Symbols
1) Press Wi-Fi Symbol
2) Turn Wi-Fi Switch ON
3) Select ‘Wlan Setting’to search for Network
4) Choose your Network and Input Password
5) Press connect button
The System Should now be connected to the internet. A
Tick should also appear next to the PC Symbol at the
bottom of the screen next to the Wi-Fi Symbol.
Step 1 : Download the 2-Easy APP

Step 4 –Testing - Setting Divert
The system has 3 different mode operations
1) Normal = No Diversion to Mobile Device
2) Divert if Not Answered = Divert after time (default 20 Seconds)
3) Divert Always =Divert to phone
4) Divert and ring monitor simultaneously
-From the Menu, select Settings, select General
Press the arrow > up the top right
Change ‘Screen on in divert’ to [Enable]. The intercom will now display on the monitor while initiating a call to your
device
Once diversion is set –Place a call to test diversion function
Divert Time –When set for Divert if not answered (currently 20 Seconds) the time can be adjusted before diversion starts
IMPORTANT INFORMATION
-This intercom can work as a stand-alone intercom, no requirements for WI-FI or mobile app services
-Speeds greater than 1.5Mbps upload are recommended at the monitor for reliability and quality
-Many ISP’s restrict activity within supplied routers/modems. An IT specialist may be required to ‘unlock’ these
restrictions. This may fall outside standard installation and Dorani technical support as it is as third party device
-Dorani bears no responsibility for connection problems caused by 3rd party equipment such as modems, routers
and mobile devices
-Warranty does not apply if the connection issues are 3rd party related
IOS TROUBLE SHOOTING
Some IOS and Wi-Fi settings restrict the account becoming connected. This is IPv6 which does not support the SIP calling
Once connection setting have been done, Select Menu Bars on APP
-Select Settings
-Select Network Settings
-Scroll down and turn IPv6 to OFF
-This should fix the connection problem.
If there is no picture on 4G
-Go into settings on the APP
-Go to Call Settings
-Turn inband DTMFs OFF
-Turn Send SIP INFO DTMFs ON
Select Call Scene and Desired Function