Dosch&Amand DA1280 User manual

-1-
DA1280 Configuration PC Application
Manual
Page
1 Installation
2 Connecting device
4 Registration
5 Configuration
6 Firmware Update
7 Reset to factory settings
Installation
1. After download and unzip .zip file
2. Start installation by clicking on the setup file
During installation, you may be asked if you want to install the device
drivers, confirm the driver installation

-2-
Connecting device
1. Connect the device to computer by using a micro USB cable
When the device is connected to the computer for first time, the
driver installation will be finished. Please wait until it is done.
2. Start the application
3. On page “Start”, “USB Port” is set to “Automatic”or device
label, press „Connect“

-3-
4. On “Info” page the RFPI of the base station where the device is
registered is displayed. Additionally the device IPEI can be seen
in hexadecimal and decimal (sometimes needed for PBX
registration) format

-4-
Registration
1. Select the "Register" page and under “Base PIN” enter the same
PIN (up to 8 digits) which is set at base station
2. Set the base station into registration mode
3. Click the “Register”button on “Registration” page,
if registration was successful, “Registration status” is set to
“Subscribed”
4. You can deregister the device by clicking the “Deregister” button

-5-
Configuration
On the "Configuration" page, you can modify the device parameters,
further described in the device manual.
The "Save" button transfers the parameters to the device.

-6-
Firmware update
1. Select the file of new firmware on the "Update" page under
"Firmware selection"
2. Start the update by clicking the “Start” button

-7-
Reset to factory settings
1. On the "Reset" page, slide the switch to right "reset”
2. Start the reset process by clicking the “Start” button
3. Close the application by clicking “Exit” tab
4. Unplug the USB cable from PC and plug it in again
(If the device is plugged into a power socket, please pull it out to
interrupt the power supply of the device!)
5. After some seconds, the DECT LED in the middle flashes red,
factory settings are recovered again