Drieaz Dragon X2 Operating instructions

Programming the Dragon X2 Thermostat
The remote thermostat supplied with the Dragon X2 Mobile Furnace provides precise,
programmable temperature controls. When properly programmed, the thermostat will cycle the
Dragon on and off to maintain precise temperature range in the target area based on the settings
you program. The thermostat can be programmed in either degrees Fahrenheit or Celsius.
Programming Instructions
Note that the temperature sensor is located at the end of the cable, and should be placed inside the
environment you wish to heat. For best results, place the sensor away from drafts, windows, and any
equipment that may produce temperature variations.
1. When the Dragon is plugged in and the ON/OFF switch is turned to the Thermostat position, the
thermostat will display the ambient temperature.
The thermostat shows the current ambient temperature when connected to the Dragon.
2. Press the SET key once to access the Fahrenheit/Celsius select mode. The display will show the
current status, either F for Fahrenheit or C for Celsius. To switch between the two modes, press either
arrow key. Choose either F or C.
Choose either the Fahrenheit (F) or Celsius (C) mode.
Service Questions: Contact Dri-Eaz at [phone]
Sales Inquiries: Contact Sylvane at [phone] or visit sylvane.com

3. Press the SET key again to access the set point. The display will blink "S1" and show the current set
point in degrees. The set point is the maximum temperature you wish to maintain in the target area.
For example, with a set point of 85°F, the Dragon will stop heating when the temperature exceeds
85°F.
Use the arrows to choose a set point.
Use the arrows to choose the desired temperature setpoint
4. Press the SET key again to display the current “setback” or temperature differential setting. The
display will blink "DIF 1" and show the current differential. Press the up or down arrow keys to select a
differential. The differential is the number of degrees the temperature will drop below the set point
before the thermostat initiates another heating cycle. In other words, the differential determines the
minimum temperature of the target area.
For example, with a set point of 85°F and a differential of 5°, the Dragon will begin a heating cycle
when the temperature of the target area drops below 80°.
You can select a differential ranger from 1° to 30°.
Use the arrows to select a differential
5. Press the SET key again to access the heating or cooling programming mode. The display will show
the current mode: either C1 for cooling or H1 for heating. IMPORTANT! Make sure the thermostat is
set to H1 for the heating mode. The Dragon will not function properly with the thermostat in cooling
mode.
Use the arrow keys to select H1 for the heating mode.
Service Questions: Contact Dri-Eaz at [phone]
Sales Inquiries: Contact Sylvane at [phone] or visit sylvane.com

6. Press the SET key once more to complete the programming of the thermostat.
The Dragon X2 thermostat is now ready for use.