Wiring Primary –R-1/T-1 of GS30XX to RING/TIP of control panel, DC power from control panel or
DC transformer to DC input, backup battery if JP3 OFF.
Wiring Backup –Incoming line to RING/TIP on GS30XX, R-1/T-1 of GS30XX to RING/TIP of control
panel, R-1/T-1 of control panel to house phones, DC power from control panel or DC transformer to DC
input, backup battery if JP3 OFF.
Testing Communications –when the GS30XX transmits a signal for the control panel, or for an
internal transmission, the YELLOW light will flash one time when the signal is transmitted and two
times when it gets a kissoff.
SIM –the SIM should be activated at least 24 hours prior to installation. The GS30XX will not show
signal strength until the SIM is active.
Panel Programming –the control panel should be programmed to communicate Contact ID exactly
the same way it would be programmed to communicate Contact ID over the telephone line.