INSTALLATION MANUAL
DM-WFC2 / 3 WFL1 - WIFI REMOTE CONTROLS
Page: 5
Electrical connection
DM-WFC3
DM-WFC3 is a remote control for electric locks, gate openers or garage doors. It provides an impulse
contact that operates the device and also a status contact that you can optionally connect to signal to the
remote control whether the door is open or closed. You can use this remote control for all devices that
require an impulse command instead of an ON / OFF switch.
LN = Connect the 110-250V AC power supply
S1-S2 = Connects the electric lock or gate opener command (NO contact closes for 2 seconds at each
command)
S3-S4 = Connect a contact that closes when the door is closed
Terminals S1-S2 provide a 3 second pulse whenever a remote command is executed. If you have other
local buttons to control the door or gate, you can connect them in parallel on the same control terminals.
If your drive (electric lock, garage door, etc.) has a contact that closes when the door is closed, you can
connect this contact to inputs S3-S4, so our app can tell you with certainty whether the door is open or
closed.
Here is a practical connection diagram
DSE SRL - ITALY - WWW.DSE.EU
