Timotion TDH8 User manual

Hand Control Programming-TDH8
Version 3 August 2021
1 of 7
1
20210811
User Manual
Hand Control
Programming-
TDH8

Hand Control Programming-TDH8
Version 3 August 2021
2 of 7
2
Contents
Contents .....................................................................................................................................................................2
Disclaimer ..................................................................................................................................................................3
1. User Interface Guide.............................................................................................................................................4
2. Reset....................................................................................................................................................................5
3. Adjusting the Height.............................................................................................................................................6
4. Setting the Upper and Lower Height Limit ............................................................................................................6
5. Power Saving Function - Waking Up the Control ...................................................................................................7
6. Restore Factory Setting ........................................................................................................................................7

Hand Control Programming-TDH8
Version 3 August 2021
3 of 7
3
Disclaimer
This user manual is ONLY for generic TiMOTION products. Manufacturers may have altered product settings
causing them to differ from this user manual. Please contact the manufacturer for a revised manual if the
product settings are different than this manual.

Hand Control Programming-TDH8
Version 3 August 2021
4 of 7
4
1.User Interface Guide
Logo
Up and down buttons
Up and down buttons

Hand Control Programming-TDH8
Version 3 August 2021
5 of 7
5
2.Reset
1. Simultaneously press and for 3 seconds. Continue pressing the buttons until both columns are
in the lowest position. When finished with the reset, the control box will make a “beep” sound and the
buttons can be released.
2. Users must conduct a reset when operating the desk for the first time.

Hand Control Programming-TDH8
Version 3 August 2021
6 of 7
6
3.Adjusting the Height
Press or button until the desk reaches the preferred height.
4.Setting the Upper and Lower Height Limit
A. Setting the upper height limit:
(1) Adjust the desk to the preferred upper height limit.
(2) Press and buttons together for less than 3 seconds, holding and release button. (Note 1)
(3) Re-press for more than 3 times at a slow pace.
(4) A beeping sound will notify you that the process has been completed.
B. Disable the upper height limit:
(1) Move the desk to the upper height limit being set.
(2) Repeat instructions #2~4 above to disable the upper limit setting.
C. Setting the lower height limit:
(1) Adjust the desk to the preferred height of lower limit.
(2) Press and buttons together for less than 3 seconds, holding and release button. (Note 2)
(3) Re-press for more than 3 times at a slow pace.
(4) A beeping sound will notify you that the process has been completed.
D. Disable the lower height limit:
(1) Move the desk to the lower height limit being set.
(2) Repeat instructions #2~4 above to disable the lower limit setting.
Note 1: Some control boxes may not support setting the upper and lower height limit functionality.
Note 2: More than 3 seconds will direct to “Reset” mode.

Hand Control Programming-TDH8
Version 3 August 2021
7 of 7
7
5.Power Saving Function - Waking Up the
Control
The digital display automatically turns off if no buttons are pressed within 25 seconds. Press any button
to light up the display again.
The system goes into <0.1W standby mode (Note 3) if no buttons are pressed within 30 seconds. Long
pressing any button will wake up the system and show desk height on the digital display.
Note 3: It depends on the control box whether it will support 0.1W standby mode or not.
6.Restore Factory Setting
(1) Refer to Chapter 2-Reset: after the “beep” sound, press and buttons together for 15 seconds, the
control box will twice make a “beep” sound.
(2) The settings below will restore to the original factory settings:
Memorized position
Desk starting height
Upper and lower height limit
T-touch or TCS1 sensitivity