INSTALLATION MANUAL
IN-APW1 – Outdoor Access Point
Page:10
WAN) and creates its own local wifi network with IP addresses of a different class than the main
network. By default, in its internal network, the AP will assume the address 192.168.10.1 and will assign
DHCP addresses with this class (192.168.10.xxx) to the devices that connect to its WiFi network or its LAN
network port. If you connect the mobile phone to the wifi network of the AP you can check the IP address
that has been assigned to you directly from the phone, as in the images below. Your phone will have an
address like 192.168.10.xxx, which is different from the main wired network, but will still communicate to
the internet because the AP acts as a router to the upstream network.
The router mode wizard allows you to configure:
1 – The network setting of the AP in the main wired network on the WAN port (fixed IP or DHCP or PPPoE
supported). It is advisable to leave the DHCP default setting so that the AP receives an automatic IP from
the router.
2 – The network setting of the AP in its local network (WiFi and LAN port). The factory setting is
192.168.10.1 and it is recommended not to change it unless strictly necessary.
3 – Setting up the wifi network generated by the AP by personalizing the name (SSID) and any password.
Once the router mode has been saved, you will be able to access the AP configuration by connecting to
the AP and recalling its internal network address, factory default 192.168.10.1
DSE SRL – ITALY – WWW.DSE.EU
