Dualit Classic Polished Kettle User manual

Classic Jug Kettle
Instruction Manual & Guarantee
IMPORTANT SAFETY PRECAUTIONS
READ ALL INSTRUCTIONS
BEFORE USING THE KETTLE KEEP THESE
INSTRUCTIONS FOR FUTURE REFERENCE
• This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by children, unless they are older
than 8 years and supervised.
• Keep the appliance and its cord out of reach of
children less than 8 years.
• Appliances can be used by persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved.
Connecting to the mains supply:
• Check that the voltage marked on the appliance
corresponds with the supply voltage.
• NOTE: any plug cut from the power supply cord
should be disposed of immediately. Inserting any
cut off plug into a 13A socket-outlet is hazardous.
• Never use the plug without the fuse cover
tted. Ensure replacement fuse is the same
current value as the original. Replacement fuses
are available and should be ASTA approved to
BS1362.
• NOTE: when you lift the kettle from the base,
you will see drops of moisture on the surface
of the power base. This is the steam used to
switch the kettle off automatically, which then
condenses and escapes through vents in the
underside of the kettle. This is perfectly normal,
and should not be cause for alarm or returning
the kettle.
• Do not operate any appliance with a damaged
lead or plug, or after the appliance malfunctions
or has been damaged or dropped in any manner.
If the mains lead is damaged, it must be replaced
by a special cord set available from Dualit’s
Customer Helpline on [phone]
• Do not use the kettle for any purpose other than
heating water. Otherwise, this may result in an
injury caused by misuse.
• Do not place the kettle, power base or mains
lead on or near any hot surface, hot hob or
gas burner.
• To be protected against electrical hazards, do
not immerse the mains lead, plug, power base or
kettle in water or any other liquid.
• This appliance is intended for household use
only. If the appliance is used improperly or for
professional or semi-professional purposes or
if it is not used according to these instructions the
Guarantee becomes invalid and Dualit refuses any
liability for damage caused.
•THIS IS AN ATTENDED APPLIANCE
Do not leave appliance unattended during use, uplug
after each use (risk of re if an unattended appliance
is left operating).
• Ensure that the kettle is correctly positioned on the
power base before switching on.
• Do not ll above the bottom of the ‘max’ mark on
the water level indicator.
• Do not operate the kettle on an inclined plane.
• Do not use in bathroom or outdoors.
• Do not store or use in an appliance garage or under
cupboards.
• Do not operate the kettle unless the water lter is
correctly in position.
• Remove the kettle from its power base before lling
or pouring.
• Do not operate the kettle unless it contains at least
250ml of water and the oor of the kettle is covered.
• Ensure that the lid is fully closed before switching the
kettle on, otherwise it may not properly switch off.
• Do not move the kettle while it is switched on.
• Use handles or knobs – do not touch hot surfaces.
• If the kettle is overlled, boiling water may be ejected.
• When boiling, hot steam will be emitted from the
kettle. Scalding may occur if you are within 400mm
of the spout.
• Scalding may occur if the lid is opened during the
boiling cycle and the body of the kettle will get hot.
• Take care when pouring – pour slowly and do not
over-tilt the kettle.
• Water will remain hot for a considerable time
after boiling and can present a scald hazard. Keep
the kettle, power base and the mains lead away
from the edge of worktops and out of the reach of
children.
• Allow the kettle to cool down completely before
cleaning and storing.
• To disconnect, turn any control to off, then remove
plug from wall outlet.
• Unplug the power base from the wall socket when
not in use, or before moving and cleaning.
• CAUTION: to prevent damage to the appliance, do
not use alkaline cleaning agents. When cleaning, use
a soft cloth and a mild detergent.
• Use the kettle only with the power base supplied
and vice versa.
• The use of accessory attachments not
recommended by Dualit may result in re, electric
shock or injury to persons.
• A short power-supply cord is to be provided to
reduce risks resulting from becoming entangled in or
tripping over a longer cord.
SAVE THESE INSTRUCTIONS
Dualit Limited County Oak Way Crawley West Sussex RH11 7ST t: [phone] f: [phone] e: [email protected] www.dualit.com
GB-B
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE(S) SOLUTION(S)
THE KETTLE DOES NOT TURN ON
1. The kettle may not be properly connected to the power supply
or the fuse may have failed.
1. Check the plug is in the socket and the switch is turned on. Replace the
fuse if necessary.
2. Boil dry feature may have been activated. If the kettle is accidentally switched on
with no water inside, the boil-dry device will switch off the heating element to
prevent damage to the kettle.
2. Wait 10 seconds for the kettle to reset.
3. The element may have broken if the power neon illuminates but the kettle
does not boil. 3. The element can be replaced. Call customer services on 01293 652500
for servicing information.
4. The kettle does boil but the power neon does not illuminate. 4. The power neon may have blown. Call customer services on 01293 652500
for servicing information.
THE KETTLE IS SPUTTERING OUT OF THE SPOUT
1. You may have over lled the kettle. 1.1 Only ll to the max mark (1.7L).
1.2 Wait 10 seconds to allow the boiling water to settle before pouring.
2. The kettle may have descaling solutions remaining inside the body. 2. Follow the instructions from the cleaning & care section and rinse throughly.
3. The lter may not be in position. 3. Ensure the lter is in position. For spare lters call Dualit on 01293 652500.
MY KETTLE IS NOT SWITCHING OFF
1. Limescale may have built up inside the kettle. 1. Descale your kettle regularly (see cleaning & care).
2. Check the lid is rmly closed during use. 2. Pips on inner lid rim can be pushed in to create a tighter t.
3. Water may have gone down the steam tube whilst lling. You may have overlled,
tilted the kettle when lling or lled through the spout.
3. Leave the kettle for 24 hours to fully dry.
MARKS HAVE APPEARED IN THE KETTLE
1. Small brown spots can build up inside the kettle. This is not rust, small deposits of
scale which contain iron can build up inside the kettle.
1. Descale regularly (see cleaning & care).
THE KETTLE LEAKS FROM THE LID
1. The lid seal may be damaged or have a build up of limescale. 1. Replace the seal. For spare seals call Dualit on 01293 652500.
WATER DROPLETS COLLECTS ON TOP THE POWER BASE
1. This is condensation and perfectly normal. 1. Dry with non abrasive cloth.

SPOUT
WATER FILTER
VIEWING WINDOW
MAX MARK INDICATOR
POWER NEON
(RED)
POWER BASE
CORD TIDY
LID SEAL HINGED LID
LID RING
SURE GRIP HANDLE
ON/OFF SWITCH
POWER CORD
KNOW YOUR CLASSIC JUG KETTLE
1
1
Place the kettle as close to the wall
socket as possible. When in use ensure
the kettle is not placed under kitchen
cabinets. DO NOT STORE OR
USE YOUR KETTLE IN AN
APPLIANCE GARAGE OR
UNDER CUPBOARDS.
Use the shortest cord possible.
Wrap excess cord round the
cord tidy on the base of
the kettle.
Do not operate on an inclined
plane.
Do not operate in a tray.
POSITION
SETTING UP
All illustrations are for representation only, your
model may vary from illustrations shown.
3 4
3
INCLINED PLANE NOT IN A TRAY
2
2
CORD TIDY
In the interest of improving products, Dualit Ltd. reserves the right to change
the product speci cation without prior notice.
FILLING YOUR KETTLE
Ensure the kettle is unplugged. Remove the
kettle from the power base. Gently pull the lid
ring up and back to open the lid.
WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED.
Fill the kettle through the lid opening. Use at
least one cup of water (250ml). The water level
must stay below the ‘max’ mark. Save energy,
only boil what you require. Keep kettle upright
and level at all times when  lling. Do not tilt
kettle backwards. DO NOT OVERFILL OR
FILL THROUGH THE SPOUT.
Push the lid down using the lid ring to close.
WARNING: IF THE KETTLE HAS
JUST BOILED, THE LID WILL BE
HOT. USE THE LID RING TO CLOSE
THE LID.
OPEN LID CLOSE LID
BOILING WATER
1
Plug the kettle into the power socket. Press the
‘On/Off’ switch down. The power neon will
illuminate and the kettle will start to heat up.
If the kettle is accidentally switched on with no
water inside, the boil-dry device will switch off the
heating element to prevent damage to the kettle.
The kettle will automatically turn off after the
water has boiled.
To turn off before the water has boiled lift the
‘On/Off’ switch up.
Always unplug the kettle after each use.
Remove kettle from the power base.
To avoid the risk of splashing, once the kettle
has boiled wait 10 seconds then pour slowly.
Do not over-tilt the kettle.
TURN ON 3POURING
2TURN OFF
CLEANING & CARE
1 3
Unplug and let the kettle cool down
completely before cleaning. Remove the
kettle from the power base.
Wipe the outside and inside surfaces of the
kettle with a damp cloth.
Unplug and let the kettle cool. Open the lid.
Hold the top of the  lter, pull up and out of
the kettle. Rinse under a tap while carefully
brushing it with a soft brush.
Rinse the kettle out with fresh water.
DO NOT OPERATE KETTLE
UNLESS THE WATER FILTER IS
CORRECTLY IN POSITION.
Use descaling products suitable for kitchen
appliances, these are readily available online
or from most supermarkets or department
stores. Use as per instructions on the packet.
Follow these few simple steps to minimise
scale build up in your kettle: Empty the kettle
after each use; do not allow water to stand in
the kettle overnight. Use  ltered water instead
of tap water. Descale the kettle regularly, at
least once a month. If you live in a hard water
area you may need to descale more often.
When descaling has  nished, empty the
kettle and rinse it out a minimum of 3 times
with fresh water, then re ll with fresh water,
boil, then discard boiled water. FAILURE
TO DO SO CAN CAUSE INJURY.
DO NOT BOIL KETTLE WITH
DESCALING SOLUTION IN IT.
THE BODY 2WATER FILTER DESCALE REGULARLY
KETTLE REPAIR
Core components of your kettle are replaceable!
The Classic Kettle has been built to last, but should you experience any fault with your kettle, please contact Dualit for advice. The
Classic Kettle is repairable and  tted with a patented, repairable element. Simply contact our helpline on 01293 652 500 or visit www.
dualit.com/support for repair or servicing advice.
All servicing must be carried out by Dualit or authorised repair agent.
For your own protection only use original Dualit spares in your kettle. Fitting of non Dualit parts will invalidate the guarantee.
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
P
L
U
G
I
N
B
E
F
O
R
E
U
S
E
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
P
L
U
G
I
N
B
E
F
O
R
E
U
S
E
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
P
L
U
G
I
N
B
E
F
O
R
E
U
S
E
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life cycle. Please hand
it over to a collection point for the recycling of electrical and electronic appliances. The symbol on the
product, the instruction of use or the packaging will inform you about the methods of disposal. The
materials are recyclable as mentioned on its marking. By recycling, material recycling or other forms of
re-utilization of old appliances you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorised disposal location.
FILLING