Dutchbone CABINET CLASS User manual

1. 100%
A
B
CABINET CLASS
ASSEMBLY INSTRUCTIONS
B
x1
x2
x4
BODY
HANDLE
A
QtyComponents
Code
QtyComponents
Code
Parts Check List
Fittings Check List
01 DOME SCREW
- Please do not discard any of the packaging until you have checked all the
parts and the hardware packages.
- Before you begin to assemble your new piece of furniture, please check
to ensure that all parts have been supplied.
- Follow instructions closely as deviation from them may void your warranty
and present a possible safety risk.
- It is recommended that assembly is done on a soft surface like carpet to
avoid any damage.
- Periodically check and re-tighten any fasteners. wipe down all surfaces
weekly with a clean cloth. do not clean any surfaces with harsh abrasives
or chemicals.
01
PHILLIPS HEAD SCREWDRIVER TOOL
NEEDED ( NOT INCLUDE )
ADJUST
FEET LEVELER
A

FURNITURE TIPPING RESTRAINT FOR: CABINET CLASS
Young children may be injured by tipping furniture and the use
of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection
against the unexpected tipping of furniture due to small tremors,
bumps or climbing. We recommend mounting this restraint to a
wall stud.
WARNING: This product is only a deterrent. It is not a
substitute for proper adult supervision.
InstallationInstruction:
1. Attach one of the mounting brackets securely near the top back edge of the furniture piece by inserting the
screw.Refer to picture A.
2. Determine the final position of the furniture piece. Mark location on the wall approximately 2” below the
bracket mounted to the back of the furniture.
3. Drill a starter hole into the wall stud. If wall stud is not available, drill a hole into the wall and insert plastic
anchor. Gently tap anchor until the flange of the anchor is flush with the wall.
4. Attach the second bracket by inserting and securing the screw to the wall. Refer to pictureB.
5. Align the two brackets.
6. Thread the strap through both brackets and tighten until snug.
7. Check to make sure that the brackets are firmly installed the strap is secure.
TIPPING KIT CHECK LIST
CODE COMPONENT QTY
01 PLASTIC STRAP 2
02 SCREW 4
03 NYLON WALL PLUG 2
04 METAL BRACKET 4
BACK SIDE
AB
THE WALL
04
02
03
01