DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2021.02.01
dux.com dux.com DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2021.02.01
32
THE HAND CONTROL
CONSUMER CAUTION
POWER RESERVE
Do not sit on the head or foot end while
adjusting the bed.
head end up head end down
both head and
foot end up
both head and
foot end down
foot end up foot end down
The motor comes with two 9 volts batteries. The batteries are used to lower the ends to their
original at position in the case of a power failure. (Test batteries often)
NOTE: The bed cannot be raised with only battery power.
TROUBLE SHOOTING
PROBLEM
Lift motors do not work at all.
POSSIBLE CAUSE AND CORRECTION
Power at wall outlet may be out; reset circuit breaker.
Power cord may be unplugged; plug in cord.
Hand control batteries are low; replace batteries.
PROBLEM
Head or foot section will not go all way down.
POSSIBLE CAUSE AND CORRECTION
Head or foot section may have an obstruction.
Move the bed to the up position, then remove the obstruction.
If the problem persists, contact Customer Service.
PROBLEM
Head or foot end will not go up or starts and stops intermittently.
POSSIBLE CAUSE AND CORRECTION
Contact the DUXIANA store or a DUX reseller.
All replacements and service should be performed by a DUX authorized service dealer.
V. LOWER THE BED
AND ADD THE SPRINGTOP
Lower the bed to the original at position
and add the springtop with
the split at the head end of the bed.
IV. ADD THE COVER TO THE RETAINER BAR
