DVMEGA Cast Quick start guide

1
AMBE Server upgrade instructions
The Swiss army knife for Digital Voice
DVMEGA Cast
Upgrade manual

2
Table of contents
General .……………........………..…………… 3
Preparation …………............………………….. 4
Configuration ……....……..…………………….. 5
Date : 18-03-2019
Version : 1.00
Author
: Guus van Dooren
URL : www.dvmega.nl
E-Mail : [email protected]

3
General
General
The DVMEGA Cast is equipped with an option connector to
which a DVMEGA DVstick30 can be plugged into to enable
the AMBE Server.This manual explains you how this option is
placed and configured.
Read the user manual completely and carefully before use.
The user manual is part of the product and contains important
information for correct use.
Keep this user manual. The user manual must be available
for uncertainties and passing the product.
The upgrade kit contains the next parts :
- DVstick30

4
Preparation
Preparation
Remove the top cover, remove 2 screws on each side of the
device.
Plug DVMEGA DVstick30 in right angled USB connector.
Now you can replace the top cover.

5
Configuration
Configuration
The AMBE Server will start
automatically when DVMEGA
DVstick30 is detected.
You only need to find out the
assigned IP address for
configuration of BlueDV.
You can find the assigned IP
address on the INFO screen on your
DVMEGA Cast.
Press INFO to show IP Info.
BlueDV for Windows
Set AMBE Settings as screenshot
on the right.
DMR ID is your personal ID without
any extension.
Host/IP is the assigned IP address
to the DVMEGA Cast.
Save settings and return to the main screen. Start SERIAL
and the desired mode.

6
Configuration
BlueDV for Windows
Set AMBE Settings as screenshot on
the right.
AMBEServ IP is the assigned IP
address to the DVMEGA Cast.
Screenshot is an example.
Submit settings and return to the main screen. Select desired
mode and connect.