Dyconn HWV37028TW User manual

Thoroughly read all instructions before installing the enclosed product.
Read and take note of all safety, care, and maintenance information.
Product Features:
Make up mirror full brightness
output at 6000K.
12 X High Power LED Bulbs
Touch Dimmer switch on lower center
with 3 Prong US Plug
Hollywood LED Vanity Mirror
Sizes: 28.3”W x 70.8”H x 2.36” D
Model: HWV37028TW

1
28.3" (72cm)
70.8" (180cm)
2.36”
(6cm)
Light Control
LED Bulbs Hanging
Holes
Hanging
Holes
Mirror
DC Port
Model: HWV37028TW
Sizes: 28.3”W x 70.8”H x 2.36” D
Product Features: Package Content:
LED backlit Mirror
Screws
Studs
Power Adapter
Manual
Make up mirror full brightness
output at 6000K.
12 X High Power LED Bulbs
Touch Dimmer switch on lower center
with 3 Prong US Plug
* All diagrams are for reference only. All model dimensions and proportions will vary.
Front View Side View

2
Tools & Preparation
IMPORTANT WARNING
TOOLS REQUIRED (not included)
Tape Measure Electronic Drill Spirit level
Pencil Philips Screwdriver Hammer
Warning: Always switch o the electrical supply at the mains during installation
and maintenance.
Do not switch on the electrical supply at the mains until the end of the installation.
This product is fragile and easily breaks with glass, be cautious while tting or handling to
prevent personal injury or damage. If the glass is broken, please stop using it and replace
it with the manufacturer. Ensure the mounting surface is dry and strong enough to bear
four times the weight of the product for safe tting.
Special care should be taken when drilling walls to avoid hidden pipes or electrical cables.
This product covers the outlet box and the wirings after installation.
Wipe clean with a soft dry cloth. Never use abrasives or chemical cleaners.
Please put a soft cushion under the mirror while you take the mirror down from the wall.

3
Back View
Wall hanging Installation
STEP 1 On the back of the mirror,
use tape to measure the distance
between two hooks
STEP 2 Mark the measured distance
on the wall.
STEP 3 Drill the holes at the marks.
STEP 4 Hammer in the expansion
tube into the wall.

4
Turn on the light.
Continue to rotate to increase
the brightness of the bulb.
Connect the power to use LED Mirror lights.
Disconnect the power to o LED Mirror lights.
Wall hanging Installation
Turn On/ O
STEP 5 Use screwdriver to lock in
the screw into tht expansion tube.
STEP 6 Carefully hang the mirror on
to the holes on the back. You may
need another person to assist.

Warranty