Dynabrade 67500 Manual

Heavy Duty Adjustable Machine Pedestal Setup
The 67500 Adjustable Machine Pedestal will be pallet shipped to its destination. The following details will describe the
steps required for initial setup before mounting of machiner and use. Read through the entire setup procedure to full
understand its requirements before tr ing to mount machiner .
Crank Arm
Tool
Mounting
Plate
Bolt Do n
Base
Lock Do n
Handle

Heavy Duty Adjustable Machine Pedestal Setup
The Adjustable Machine Pedestal must be securel bolted to the floor. After determining a location, use dimensions
below to la out the hole locations before beginning to drill into concrete floor. The base mounting holes were sized to be
used with a threaded concrete anchor and ½” bolt.

Heavy Duty Adjustable Machine Pedestal Setup
Before mounting of tool, be sure to lock pedestal to a fixed position b turning the Lock Down Handle clockwise until
tight. This will insure a stable assembl for positioning our tool to the mounting plate surface. Align tool base to hole
pattern on pedestal and insert 5/16” bolts at all four mounting points, making sure to use washers and locknuts as shown
in detail below. Continue b locking down all four bolts rigid to pedestals tool mounting plate.
Mounting Hard are as sho n provided:
4 64239 5/16-18 Lock Nut
4 95183 Washer
4 95036 5/15-18 X 1-1/4” Hex Screw
Lock Do n
Handle
Tool
Mounting
Plate
Lock Do n
Un-Lock

Heavy Duty Adjustable Machine Pedestal Setup
You can now begin to adjust the pedestal to our desired work height. Begin b turning the lock down handle counter
clockwise just until loose. To raise the pedestal, rotate the crank arm in the clockwise direction until ou reach the
desired height. The maximum height is 38” from floor to base of tool mount plate. When crank has reached the
maximum height, there will be resistance to crank. At this time, return the crank one half turn in the counter-clockwise
direction and secure pedestal at this location with the lock down handle, turning it in the clockwise direction as shown.
To lower the pedestal, rotate the crank arm in the counter- clockwise direction until ou reach the desired height with a
minimum of 28”
Lock Pedestal at desired height
RAISE
LOWER