Dynamix 10/100/1000 (SFP) User manual

6. Application Diagram
7. Troubleshooting
Diagnosing Media Converter Indicators
Dynamix Media Converter can be easily
monitored through its comprehensive panel
indicators. These indicators assist in
identifying problems the Media Converter
may encounter. This section describes
common problems you may encounter and
possible solutions
1. Symptom: POWER indicator does not
light up (green) after power on.
Cause: Defective External power supply
Solution: Check the power plug by plugging
in another that is functioning properly. Check
the power cord with another device. If these
measures fail to resolve the problem, have
the unit power supply replaced by a qualified
distributor.
2. Symptom: Link indicator does not light up
(green) after making a connection.
Cause: Network interface (ex. a network adapter
card on the attached device), network cable, or
switch port is defective.
Solution: 2.1 Verify if both of the switch and
attached device are powered on.
2.2 Be sure the cable is plugged into both the
switch and corresponding device.
2.3 Verify that the proper cable type is used and its
length does not exceed specified limits.
2.4 Check the Adapter on the attached device and
cable connections for possible defects.
2.5 Replace the defective Adapter or cable if
necessary.
8. Compliance and Safety Information
FCC Warning
This equipment has been tested to comply with the
regulations for a Class A digital device, pursuant to
Part 15 of the FCC Rules.
These regulations are designed to provide
reasonable protection against harmful interference
when the equipment is operated in a
commercial environment. This equipment can
generate, use, and radiate radio frequency energy
and, if not installed and used in accordance with
the instruction manual, may cause harmful
interference to radio communications. Operation of
this equipment in a residential area is likely to
cause harmful interference in which case the user
will be required to correct the interference at
his/herown expense.
CE Mark Warning
This is a CE class A product. In a domestic
environment, this product may cause radio
interference in which case the user may be
required to take adequate measures.
www.godynamix.com
Dynamix 10/100/1000 (SFP)
Media Converter
User Manual
V. 1.2

Dynamix 10/100/100 (SFP) Media
Converter
1.Overview
Dynamix Media Converter is a converter that
translates transmission signals from a twisted-
pair 1000BASE-TX cable (UTP) to
1000BASE-FX fiber optic cable. The converter
automatically adapts to the highest level of
performance supported by the device
connected to the Ethernet port. When the device
is a switch or a workstation that supports full-
duplex, the converter adapts to the
full-duplex mode and provides an effective
2000Mbps bandwidth. When the device
connected is a hub or a workstation that supports
only half-duplex, the converter adapts to the half-
duplex mode and provides the nominal
1000Mbps bandwidth.
Dynamix Media Converter supports conversion
between 10/100/1000Base-T and 1000Base
SFP, that is standard Small Form-factor
Pluggable (SFP) Gigabit Ethernet fiber optic
modules (multi-mode, single-mode, WDM).
With high performance of data transmission and
easy installation, Dynamix media converter can
build the ISP network solution of FTTH(Fiber to
the Home) or FTTC(Fiber to the Curb) for
ISPs(Internet Service Providers) and FTTB(Fiber
to the Building) also for
small office network environment of enterprises.
2. Specification and Feature Explain
1. Supports auto-MDIX and 10/100/1000Base T for
RJ-45 port
2. Complies with IEEE 802.3 10BaseT, IEEE 802.3u
100Base-TX, IEEE802.3ab 1000Base-T, IEEE802.3z
1000Base-SX / LX
3. Supports all of standard SFP transceiver connecting
as multi mode/ single mode/ WDM
4. Data Transfer Rate: 1000Mbps
5. Duplex mode support: Full or half-duplex mode by
Auto-Negotiation
6. Store-and-Forward Mechanism
7. Compact in size and easy installation
8. EMC certified by CE and FCC
9. RoHS compliant
10. Operating temperature 0°C - 50°C
11. Storage Temperature -20°C - 65°C
12. Humidity 10 to 90% (non-condensing)
13. Dimension 108mm x 80mm x 26mm
14. External Power Adapter - Input: AC 100~240
volts/50~60Hz; Output: DC 12V/1A.
3. Unpacking Information
Check List
Carefully unpack the package and check its
contents against the check list.
Package Contents:
1. Giga Media Converter
2. AC to DC (12V) Power Adapter
3. User’s Manual
Please inform your dealer immediately for any
missing, or damaged parts.
If possible, retain the carton including the original
packing materials and use them to repack the unit
in case there is a need to
return for repair.
4. Hardware Description
Front Panel
Rear Panel
5. LED Indicators