Dynojet POWER COMMANDER III User manual

2002-2004 Honda VFR800 VTEC - PCIII - 1i111-211
2002-2004 HONDA VFR800 VTEC
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 [phone] www.powercommander.com
Installation Instructions
Parts List
1 Power Commander
1 CD-ROM
1 Installation Guide
2 Power Commander Decals
2 Dynojet Decals
1 Velcro®Strip
1 Alcohol Swab
You can also download the Power Commander software
and latest maps from our web site at:
www.powercommander.com
The ignition MUST be turned OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

7 Route the PCIII wiring along the
inside of the frame towards the
rear of the bike (Fig. C).
1 Remove the main seat.
2 Remove the front two fuel tank
mounting bolts.
3 Prop the front of the fuel tank
up.
4 Locate the throttle body wiring
harness connector (Fig. A). This
connector is located on the right
hand side of the bike under the
right, rear corner of the air box.
5 Unplug the connector shown in
Fig. A.
6 Plug the connectors from the
PCIII in-line of the stock wiring
harness (Fig. B).
Fig. B
Fig. C Fig. A
2002-2004 Honda VFR800 VTEC - PCIII - 2i111-211 www.powercommander.com
Unplug this connector
PCIII harness
Stock connectors
PCIII connectors

8 Route the ground wire from the
PCIII harness under the frame
towards the battery. Attach
ground wire from PCIII to the
NEGATIVE terminal of the bat-
tery.
9 Install the PCIII in the rear sec-
tion of the trunk using the sup-
plied velcro (Fig. E). Make sure
to clean both surfaces first with
alcohol.
Fig. DFig. E
2002-2004 Honda VFR800 VTEC - PCIII - 3i111-211 www.powercommander.com
PCIII harness
Ground wire