Dynojet POWER COMMANDER III User manual

2006-2007 Honda VFR800 - PCIII USB - 1i126-411 www.powercommander.com
2006-2008 Honda VFR800 VTEC
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 [phone] www.powercommander.com
Parts List
1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide
1 Power Adapter
2 Power Commander Decals
2 Dynojet Decals
2 O2 eliminators
2 Velcro®Strip
1 Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB Port
Expansion Port

1 Remove the main seat.
2 Remove the front two fuel tank
mounting bolts.
3 Prop the front of the fuel tank
up.
4 Locate the throttle body wiring
harness connector (Fig. A). This
connector is located on the right
hand side of the bike under the
right, rear corner of the air box.
5 Unplug the connector shown in
Fig. A.
6 Plug the connectors from the
PCIII in-line of the stock wiring
harness (Fig. B).
Fig. AFig. B
2006-2007 Honda VFR800 - PCIII USB - 2i126-411 www.powercommander.com
Unplug this connector
Stock connectors
7 Route the PCIII wiring along the
inside of the frame towards the
rear of the bike (Fig. C).
Fig. C
PCIII harness
PCIII connectors

9 Install the PCIII in the rear
section of the trunk using the
supplied velcro (Fig. E). Make
sure to clean both surfaces first
with alcohol.
10 Remove the left hand side
fairing.
Fig. E
8 Route the ground wire from the
PCIII harness under the frame
towards the battery. Attach
ground wire from PCIII to the
NEGATIVE terminal of the
battery (Fig. D).
Fig. D
2006-2007 Honda VFR800- PCIII USB - 3i126-411 www.powercommander.com
Ground wire from PCIII
PCIII harness
11 Locate the stock O2 sensor
connections (Fig. F). Unplug
both the front and rear exhaust
O2 sensors.
12 Plug the Dynojet O2 eliminators
into the stock wiring harness in
place of the stock O2 sensors.
The stock O2 sensors no longer
need to be connected to any-
thing.
13 Reinstall the fairing, fuel tank,
and seat.
Fig. F
Unplug