RESET
Press all four buttons for 5 seconds and release. This
will re-set the internal computer (this only needs to be
done after a battery change).
HOW TO SET AN ALARM SPECIFIC DATE
AND TIME
• Tap button C until mode prompt "ALARM" is
reached.
• Tap button B to go to the alarm you want to set.
Alarm-1 is AL-1, Alarm-2 is AL-2, Alarm-3 is AL-
3, Alarm-4 is AL-4, Alarm-5 is AL-5, Alarm-6 is
AL-6 and CHIME is the 7th alarm.
For each SPECIFIC alarm do the following:
• Press & hold button D for 5 seconds to enter
setting mode. The hours will start flashing.
• Tap A until the correct Hour is reached. Please
note the PM indicator above the Seconds.
• Tap C
• Tap A until the correct Minute is reached.
• Tap C
• Tap A until the correct Month is reached.
• Tap C
• Tap A until the correct Day of the Month is
reached.
• Tap C
• Tap A for the correct Time Zone (T1or T2)
• Tap D to leave setting mode.
Make sure ON is displayed next to the minutes. If
“ON” is not showing you can toggle to ON by
tapping A.
Proceed to your next alarm by tapping B.
Note The six (6) alarms operate independently. If
month & date of the alarm is set to "--", the alarm will
act as a daily alarm (no reset required).
HOW TO USE COUNT DOWN TIMER
The MeDose watch offers three count down timer
modes. Each mode can be up to 99 minutes and 59
seconds long (1 hour and 40 minutes).
• Tap button B to select Count Down Stop (CS),
Count Down Up (CU), or Count Down Repeat
(Cr) function.
Once you have made your count down selection:
• Press & hold button D for 5 seconds to enter
setting mode. The minutes will start flashing.
• Tap A until the correct Minute is reached.
• Tap C
• Tap A until the correct Second is reached.
• Tap C
• Tap D to leave setting mode.
Use button A to start and stop the count down
timer.
Note
1. The Count Down Timer features 1 second
increments with a working range from 1 second
to 99 minutes 59 seconds.
2. The watch will sound 3 beeps at 3 minutes, 2
beeps at 2 minutes, and 1 beep at 1 minute
before the timer counts down to zero. The
watch will beep for 5 seconds when the timer
reaches zero.
3. When the timer is stopped, pressing button B
will change the timer function and the preset
time will be reloaded.
In Count Down Up (CU) function, as the time is
counting up after the timer counts down to zero, an
arrow pointing upwards will be displayed.
Battery:
Replaceable CR2032 3V Button Cell
We suggest you take the watch to a
jeweler to have the battery replaced.
