Eagle Group Panco User manual

ASSEMBLY INSTRUCTIONS
Panco®Display Rack
Parts List
EG10039 Revised 03/05
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group. ©2005 by the Eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: [phone] • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: [phone] or 302/653-3036
#qty description
#1 1 18˝ x 30˝ wire shelf
#2 1 three sided truss frame
#3 1 single truss frame 30˝
#4 1 Panco®display sign
#5 1 top display shelf
#6 2 40˝ post
#7 2 63˝ post with velcro
#8 3 bags of 4 split sleeves
qty description
1 peel-off label for display pan
(not shown)
#1
#2
#3
#4
#5
#7
#6
#8
Step 1 - Attach split sleeves
(for bottom shelf) to posts.
Snap split sleeve onto each post at
the bottom groove covering #3 (the
wider part of the taper goes toward
the bottom).
split
sleeves
3
split
sleeve
shelf
collar
post
Step 2 - Assemble bottom shelf to posts.
Note: Make sure the velcro on rear posts are facing towards the front.
PART #A206226
CAUTION
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER FOR ANY
DAMAGE.SAVE YOUR BOX AND ALL PACKING MATERIALS. YOU ARE RESPONSIBLE
FOR DAMAGE TO YOUR UNIT IF RETURNED IMPROPERLY PACKED.
rear posts
(longer with
velcro)
front
posts
(shorter)

display shelf
rear truss
3-sided frame
Step 4 - Assemble 3-sided frame to posts.
Note: Long side goes to the front of the unit
(short posts).
ASSEMBLY INSTRUCTIONS
Panco®Display Rack
Step 3 - Attach split sleeves
(for 3-sided frame) to posts.
Snap split sleeve onto each post at
the groove covering #39 (top of
front posts).
split
sleeves
3-sided
channel
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group. ©2005 by the Eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: [phone] • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: [phone] or 302/653-3036
split
sleeve
corner
collar
Step 6 - Assemble rear truss to posts.
Step 5 - Attach split sleeves
(for rear truss) to posts.
Snap split sleeve onto each rear
post at the groove covering #46.
split
sleeves
split
sleeve
truss
collar
rear truss
bottom
shelf
Step 7 - Install display shelf.
Hook display shelf over rear truss with
short flange down, allowing front of shelf
to rest on 3-sided frame.
(Note: If shelf does not fit correctly,
lower rear truss.)
Load pans onto bottom shelf, load one
pan onto display shelf, and attach
peel-off label to pan on display shelf.
sign
Step 8 - Attach sign to rear posts
(using velcro supplied).
39
46