Eagle 500772 User manual

PART #353672
EG9992 Revised 03/05
Step 1
Locate the two screw holes nearest to each end of either
drawer slide.
Parts List
# qty part # description
#1 2 336255 Drawer Mounting Bracket
#2 4 313630 #12 x 3⁄4˝ Drive Screw
#3 2 300697 18˝ Drawer Slide
#4 4 301492 #10 Lock Washer
#5 4 300755 #10-24 Hex Nut
#6 1 Drawer Pan
#1
drawer
mounting bracket
hole used to attach
bracket to angle
framing of table
top set of holes
for tables with
rolled edges
middle set of holes
for tables with
square edges
bottom set of holes
for tables with
box marine edges
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group.©2005 by the Eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: [phone] • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: [phone] or 302/653-3036
screw hole screw hole
slide
#313630
pan head screw
bracket
#301492
lock washer
#300755
hex nut
pin with
black caps
#1
#2
#3
#3
#6
#4
#5
Before assembly:
• Determine applicable sets of holes
in brackets.
left-hand
bracket/slide assembly
right-hand
bracket/slide assembly
Step 2
Attach drawer slides to drawer brackets using hardware included.
Assemblies should
look like these
when completed.
ASSEMBLY INSTRUCTIONS
Drawers for Tables
with Angle Frame
(Drawers #500772, 501571, 502941, and 502942)

Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group.©2005 by the Eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: [phone] • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: [phone] or 302/653-3036
Step 3
Underneath tabletop, attach bracket/slide assemblies to angle framing of table using
hardware included.
front of
table
black rubber bumper
on slides must face
front of table
right-hand
bracket/slide assembly
left-hand
bracket/slide assembly
#300754
hex nut
angle framing
of table
#301491
lock washer
#300756
pan head screw
Step 4
Remove the black cap from the top of
each pin. Set aside but DO NOT LOSE.
drawer slide pins
drawer slides
drawer drawer handle
drawer slide pins
drawer slides
(extended)
Step 5
Lay drawer on top of drawer slides, aligning holes in
drawer to pin of each slide.
Step 6
Return black rubber caps
to both pins.
black cap
pin
qty part # description
4 300756 #8-32 x 3⁄8˝ Screw
4 301491 #8 Lock Washer
4300754 #8-32 Hex Nut
PARTS LIST
ASSEMBLY INSTRUCTIONS
Drawers for Tables
with Angle Frame
(Drawers #500772, 501571, 502941, and 502942)