E&G Classics 1409-0102-10 User manual

Chrome Plated S. S. Fine Mesh Insert
(8) 8-32 ESNA Half Nuts
Top Mounting Plate
Lower Mesh Retainer w/Pins
Remove the factory upper grille from the bumper cover
by removing the threaded push pins across the top of the
grille and the phillips screws located at the sides and
bottom of the grille .A short phillips screwdriver or
ratcheting screw driver works best (grille shown removed
to show screw locations).
. Apply masking tape around the lower grille opening.
1409-0034-10
1409-0020-10
1999-0065-00
1409-0210-10
1409-0042-10
1221-0158-09
1999-0065-00
1999-0264-00
1999-0311-00
3999-9035-00
1409-0039-10
1409-0158-10
IMPORTANT!
The exposed edges of the stainless steel
grille and mesh can be extremely sharp.
Please handle with care.
. Cut out and align the supplied ,making sure the
lines on the match the openings in the bumper
cover. Once properly aligned, tape the into place
and use an awl or similar pointed to the mark the hole
locations onto the bumper cover, then remove the
.
3
4
“BLACK ICE”S. S. Fine Mesh Insert
(8) #8-32 ESNA Half Nuts
Top Mounting Plate
Lower Mesh Retainer w/Pins
1409-0034-10
1999-0065-00
1409-0210-10
1409-0042-10
1221-0158-09
1999-0065-00
1999-0264-00
1999-0311-00
3999-9035-00
1409-0039-10
1409-0158-10
1
A
A
BB

Remove the
emblem from the factory grille. Align the factory emblem
over the supplied ,then center
the emblem onto the upper mesh grille and attach it using
the and the
.or you will
strip out the holes in the factory emblem. .
Align the with the
holes drilled in and push the pins down into the
slots. Before the is down flush against the
bumper cover, remove any protective masking tape that
could get caught underneath the .
Reinstall the factory threaded push pins across the top of
the mesh grille.
Peel off the from the
.Thoroughly clean the grilles to finish the installa-
tion.
9
8
. Align the and into the
lower factory opening in the bumper cover and use
masking tape to hold it in place while installing the
and to
secure. Tighten the nuts until the grille is snug but
!You can access the mounting
hardware by reaching down through the upper grille
opening.
7
10
. Trim the ends from the supplied
and install them over the studs on the
once the has been aligned.
5
. Use a .125”(1/8”) drill bit to drill through the marks made
in the previous step, then use the drill bit to connect the
holes making small mounting slots. This will allow for
slight left to right adjustments when installing the new
.
6
6

.
12
E&G GRILLES BILLET GRILLES