
PAGE 5
HOW TO ORDER SPARE PARTS
All spare parts listed herein may be ordered direct from the manufacturer. Be sure to give the following information when
ordering.
Model Number
Part Number
Part Description
You can contact us by calling (574) 848-7491 to place an order with a credit card, or purchase online at
www.earthway.com Questions? Email us at support@earthway.com
1 YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of one year
to the end user with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products, Inc.
at its discretion will repair or replace the part(s) or product at no charge provided the failure is not the result of incorrect
installation, mishandling, misuse, tampering, or normal wear and tear as determined by Earthway. Earthway at its
discretion may require that the part(s) or product be returned along with the original purchase receipt at owners’ expense for
from Earthway Products, Inc. To seek remedy under this warranty, contact Earthway Products, Inc. at 574-848-7491,
techsupport@earthway.com or write to Earthway Products, 1009 Maple St. Bristol, Indiana 46507 and describe the nature
of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges
thoroughly after each use, as a preventative measure, coat all metal parts with a light oil or silicon spray.
OPERATING INSTRUCTIONS
Move stop bolt on rate gauge assembly to the proper setting.
While pushing spreader forward, pull control lever back to stop bolt.
Thoroughly wash spreader and dry before storing. A coating of light oil will help prevent corrosion.
Do not allow unused rock salt to remain in hopper. It will solidify and cause damage to the GEARBOX.
™ OPERATION
The ™ lever is located under the right side of the hopper. To operate the ™,
slide the control lever from the front to the back. This will activate the ™for a PARTIAL spread
pattern and prevent material from being spread to the left side of the spreader. Position the left wheel of your spreader 4”- 6”
control lever to “0”, and then open the ™ by sliding the control lever from back to the front, for a FULL
spread pattern.
The ™
™maintains the correct application rate while it is activated, giving you excellent results in seeding or
spreading while controlling the spread pattern on the left side of the spreader.
The ™is an
EarthWay
exclusive.
OCT 2019 REV
Place ice melt where it matters...