How to Install a Tray
TIP:
STANDARD-OUTPUT
NOTE:
TIP:
How to ensure your spreader is
properly calibrated
HIGH-OUTPUT and LOW-OUTPUT
FULLY
CLOSED
FULLY CLOSED
HIGH-OUTPUT
and LOW-OUTPUT
Calibration Adjustment
TIP:CLOSE
shut-off fully closed
continued
EarthWay®Flex-Select®
Setup and Calibration Techniques
©2018 Earthway Products, Inc. All rights reserved. EarthWay®EV-N-SPRED®, FLEX-SELECT®, and SPRAY-PRO®are registered trademarks of Earthway Products, Inc.
Use of trademarks are prohibited unless approved by Earthway Products, Inc. 1009 Maple Street Bristol, Indiana 46507
STANDARD-OUTPUT
PRO F13130DKIT
Red Tray
install Pivot Rod
from the bottom
to the top
LOW-OUTPUT
F13130LKIT
Black Tray
install Pivot Rod
from the top
to the bottom
HIGH-OUTPUT
F13130HKIT
Blue Tray
install Pivot Rod
from the bottom
to the top
Deburr
Rod Clip
Shut-Off End
Shut-Off End
Shut-Off End
1
3
2
1
3
2
1
3
2
4
5
Quarter Turn
Tray Fastener
6
PIVOT
CALIBRATION
POINT
