EAST OAK EFSG009 User manual

1EASTOAK.COM OWNER’S MANUAL
3-Piece Bar Set
Owner’s Manual
MODEL:
EFSG009

12 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
Claim your 3-year warranty
at eastoak.com/warranty
Please scan the QR code
to view the installation video
Questions? Comments?
Reach out to us for expert support!
[e-mail]
eastoak.com
1-833-EAST-OAK (USA)
(1-833-327-8625) Mon-Fri 8am-8pm EST

32 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
• Some parts may contain sharp edges. Wear protective gloves if necessary during
assembly.
• When using power tools, please adjust the gear to the minimum, otherwise it will
cause damage to the parts.
IMPORTANT CAUTION
SAFETY GUIDE
NOTICE
• Tighten all bolts and screws again within the rst two weeks of assembly.
• Check the tightness of all bolts every two months, and tighten them if necessary.
CARE & CLEANING
• To obtain the longest lifespan of the bar set, clean the frame with a damp towel, and
then dry the bar set thoroughly. This will remove dirt particles and prevent mildew.
• Do not clean the bar set with abrasive materials, bleach, or solvents.
• Store the bar set in a dry, sheltered place when not in use.
READ & SAVE BELOW INSTRUCTIONS
BEFORE ASSEMBLY
1. Please separate and identify all parts, making sure that you have all of the
parts listed.
2. Assemble on a soft surface, such as carpeting, to avoid scratching the nish.
3. Please assemble step by step and follow the instructions.
4. Washers must be used.
5. While each screw and nut is properly fastened, do not over fasten it.
6. Do not completely fasten each screw and nut until all the screws are properly xed.
ASSEMBLY SUGGESTIONS
• Two adults required for a safe assembly
X2
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents. If any part is missing or
damaged, do not attempt to assemble the product. If any part is missing or damaged,
please contact customer service at [e-mail].
• For your safety and to reduce the risk of severe personal injury, the user must
read and understand this Safety Guide.
• Assemble each piece only following the instructions. Using tools or hardware not
included in the original packaging, or improperly assembly may cause the product
to malfunction or has a risk of severe personal injury.
• Assemble on a plat and soft surface, such as carpeting, to avoid scratches or damage.
• Keep the bar set out of the re, extreme heat, freezing conditions, and inclement
weather such as rain, hail, snow, or wind.
• PLEASE NOTE that the metal paint may come off due to weather conditions.
• Cleaning teak patio furniture is relatively simple, and most routines only require
a mild detergent and water mix along with a bristled brush to keep your items
looking great. Avoid using a hard brush to clean your teak furniture. Do not use any
abrasive sponges, steel brushes, wonder sponges or abrasive cleaners. They will
damage the natural, soft grain, which quickly makes the wood feel rough. Moreover,
it will also get dirty faster.
• Teak wood need to be maintained in order to keep the same color. Without
maintenance, teak wood color will become silver grey. In order to prevent this
greying process, it is necessary to brush the wood and apply a layer of oil or special
care product regularly.

54 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
PARTS LIST
M6*16 Screw M6*45 Screw M6*20 Screw
X 24 PCS + Spare X 1
KX 8 PCS + Spare X 1 LX 4 PCS + Spare X 1 M
Ice Bucket Ice Bucket Top Table support rod
X 1 PC
GX 1 PC J
X 1 PC
H
Table leg+Bottle opener hole
Table Leg
X 1 PC
DX 1 PC E
Table top
X 1 PC
F
Seat Support Rod
Chair Leg
X 4 PCS
A
Seat
X 2 PCS
BX 4 PCS C
WHAT’S IN THE BOX
• 1 x Bar Table
• 2 x Bar Chair
• 1 x Ice Bucket
• 1 x Ice Bucket Top
• 1 x Bottle Opener
• 1 x Accessory Kit
• 1 x Owner’s Manual
Screwdriver
X 1 PC
S
Spring Washer
X 32 PCS + Spare X 1
Q
D4*16 Screw
X 2 PCS + Spare X 1
R
Hex Wrench Flat WasherPlastic cap
X 28 PCS + Spare X 2
OX 36 PCS + Spare X 1 P
X 1 PC
N
Bottle Opener
X 1 PC
T

76 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
1Align the hole position
Assemble and connect the two seat support
rods with the U-shaped aluminum sheet on the
chair leg, in the meantime, ensure that the hole
positions are aligned.
PRODUCT ASSEMBLY - CHAIR
C
A
2Install screws
Fix the seat support rods and the chair leg again
with screws, and completely tighten them.
K X 4 PCS Q X 4 PCS
P X 4 PCS O X 4 PCS
A X 2 PCS
C X 2 PCS
K
M6*16mm
N
K
Q
P
O

98 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
3Align the hole position
5Post-installation inspection
After installation, check if the physical object matches
the picture.
Assemble and connect the chair legs with the four
L-shaped aluminum sheets under the seat,
in the meantime, ensure that the hole positions
are aligned.
TIPS: The chair legs are
equipped with leveling foot
pads underneath, which can
be adjusted in height when
the chair is placed on
unstable ground.
4Install screws
Fix the seat and the chair legs with screws,
and completely tighten them.
K X 8 PCS Q X 8 PCS
P X 8 PCS O X 8 PCS
K
M6*16mm O
N
P
K
Q

1110 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
1Align the hole position
Align the upper edge of the table legs with the
back of the table top, and then press tightly after
aligning the hole positions.
PRODUCT ASSEMBLY - TABLE
D X 1 PC E X 1 PC
F X 1 PC
TIPS: The side with the support
rod screw hole under the table
leg should face inward, and the
table leg with the bottle opener
screw hole should be placed on
the side of the ice bucket.
2Install screws
Attach the table legs onto the table top with
screws, but don’t completely tighten them.
L X 8 PCS Q X 8 PCS
P X 8 PCS
L
M6*45mm
E
D
F
TIPS:The screws that
x the table legs and
the table top do not
need to be covered with
screw caps.
Q
N
L
P

1312 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
3Align the hole position
Align the hole position of the table legs with the hole
position on both sides of the table support rod, and
then press tightly.
G
G X 1 PC
M
M6*20mm
4Align the hole position
Install the table support rod on the table legs with
screws, but don’t completely tighten them.
TIPS: Spring washers
do not need to be added
to the screws that x
the table legs and the
support rods.
P X 4 PCS
M X 4 PCS
O X 4 PCS
M
P
N
5Tighten screws
Tighten all screws completely.
TIPS: There are adjustable foot
pads underneath the table legs.
If the table is placed on unstable
ground, you can adjust the
height by yourself.
N
O

1514 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
6Place the ice bucket
Put the ice bucket into the table according to
its shape, and cover it with the ice bucket top.
TIPS: When taking or placing
the ice bucket, place both hands
on either side of the short edge
of the ice bucket.
J X 1 PC H X 1 PC
J
H
7Install the bottle opener
After aligning the hole positions, use a athead
screwdriver to install the bottle opener on the table
legs with screws and tighten them.
8Post-installation inspection
After installation, check if the physical object matches
the picture.
R
T
S
R X 2 PCS S X 1 PC
T X 1 PC
R
D4*16mm

1716 EASTOAK.COM3-PIECE BAR SET OWNER’S MANUAL
• The set design combines the color of dark gray and teak, creating a timeless
charm of minimalism while conveying a sense of aesthetic.
• The aluminum frame with a teak surface provides excellent material quality
and a good texture.
• The warm teak color is FSC certied, making it attractive and
environmentally friendly.
• The aluminum frame is coated with a durable and weather-resistant dark
gray paint.
• The comfortable height design of the bar stool makes you feel easy and
natural whether sitting or standing.
• The product comes with an ice bucket for chilling alcoholic beverages and
other drinks, enhancing the ambiance of outdoor living spaces.
• The bottle opener makes it easy for you to enjoy the beer. And it’s less
prone to loss.
• 304 Stainless steel screws are ideal under most circumstances, ensuring
durability and longevity.
FEATURES
• Construction Materials: Aluminium Teak
• Weight Capacity:
Chair: 280lbs.
• Assembly Time: 20-25 minutes
• Product Size:
Chair: 13.8inx13.8x29.5 inches
Table: 39.4inx23.6x41.3 inches
Ice Bucket: 11.7x9.3x9.9 inches
Ice Bucket Top: 11.7x9.7x0.8 inches
Bottle Opener: 1.77x0.98x2.91 inches
TECHNICAL SPECS
WARRANTY POLICY
GUARANTEED 3-YEAR WARRANTY
Thank you for choosing East Oak. This product is covered by our company
warranty for up to 3 years from its original purchase date.
CLAIM WARRANTY
If you’d like to claim your product’s warranty, register your new product on our
website at www.eastoak.com/warranty.
WARNING
Cancer and reproductive Harm
www.P65Warnings.ca.gov.
3-Piece Bar Set

18 3-PIECE BAR SET
[e-mail]
eastoak.com
1-833-EAST-OAK (USA)