Eazyzap CT870 User manual

Model:
CT870
Glue Trap
Instruction manual
CT870_UK_A5_v1_20181015.indb 1 2018/10/15 16:39

2
UK Telephone Helpline: 0845 146 2887
Safety Tips
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• Always switch off and disconnect the power supply to the
appliance before cleaning.
• Install the appliance out of the reach of children.
• Never insert hands or other objects into the appliance while it
is connected to the power supply.
• Install the appliance at least 1 metre away from food
preparation areas.
• Never use near flammable objects.
• For INDOOR use only.
• The appliance is not suitable for use in barns , stables and
similar locations.
• Keep all packaging away from children.
• If the power cord is damaged, it must be replaced by an
EAZYZAP agent or a recommended qualified technician in
order to avoid a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
CT870_UK_A5_v1_20181015.indb 2 2018/10/15 16:39

3
UK
Telephone Helpline: 0845 146 2887
• EAZYZAP recommend that this appliance is PAT tested on an
annual basis to ensure the product remains safe.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your EAZYZAP product.
Pack Contents
The following is included:
• EAZYZAP Glue Trap
• Instruction manual
• Detachable power cord
EAZYZAP prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your EAZYZAP dealer immediately.
Installation
1. Remove all packaging and protective film from the appliance.
2. For best results, locate the appliance in the darkest part of the room, but at least 1 metre away from
food preparation areas.
Note: Close proximity to other light sources such as sky lights and windows will
reduce the effectiveness of the appliance.
Prepare the mounting fixings (not supplied) before installation. If in doubt seek
professional advice or assistance.
3. Upon necessity you can install the appliance onto the wall as instructed below.
1
150 mm
• Drill 2 holes on the wall. Note: Ensure there is
no electric/water pipe beneath the holes.
• Insert wall plugs and screws into the holes
consecutively (Fig. 1).
2
• Hang the appliance on the screws and
ensure it rests in place (Fig. 2).
CT870_UK_A5_v1_20181015.indb 3 2018/10/15 16:39

4
UK Telephone Helpline: 0845 146 2887
Operation
WARNING: Under no circumstances should hands be placed anywhere near the
appliance when it is in operation.
The glue trap uses the specified wavelength of black light tube to attract insects. Then the insects are
drawn towards glue board and can’t escape the strength of the glue.
The glue trap is highly efficient and harmless to humans and pets. To use the appliance:
1. Connect the power cord to the appliance then to the mains power.
2. The light will come on and ready for use.
Cleaning, Care & Maintenance
Always switch off the power and disconnect the appliance from the power
supply before cleaning and maintenance.
• DO NOT immerse the appliance in water. Wipe the safety guard and external casing with a damp
cloth.
Changing the glue board and light
WARNING: Always turn Off the
appliance and disconnect from the
power supply before changing the glue
board or light.
Replace the glue board regularly (on a monthly basis). To
change the glue board, simply pull it out (Fig. 3). Replace
with a new one.
To change the light:
1. Remove the 2 screws on the metal support that is
fixing the light tube.
2. Remove the metal support.
3. Twist the light tube anti-clockwise from its socket.
4. Insert the new light and twist clockwise until tight.
5. Re-put the metal support in place.
3
Glue board
Metal support
CT870_UK_A5_v1_20181015.indb 4 2018/10/15 16:39

5
UK
Telephone Helpline: 0845 146 2887
Troubleshooting
Fault Probable Cause Solution
The appliance is
not working
The unit is not switched on Check the unit is plugged in correctly
Plug and lead are damaged Call EAZYZAP agent or qualified Technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call EAZYZAP agent or qualified technician
Tube has expired Refer to the ‘Changing the glue board and light’
section
Tube is faulty or has not been fitted
correctly
Technical Specifications
Model Voltage Power Current Dimensions
h x w x d (mm) Weight Lamp type
CT870 220-240V
50/60Hz
13W 0.15A 325 x 235.8 x 122 0.85kg E27 13W UVA
energy saving
lamp
CT870_UK_A5_v1_20181015.indb 5 2018/10/15 16:39

6
UK Telephone Helpline: 0845 146 2887
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
EAZYZAP parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
EAZYZAP products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of EAZYZAP.
Every effort is made to ensure all details are correct at the time of going to press, however, EAZYZAP reserve the right to
change specifications without notice.
CT870_UK_A5_v1_20181015.indb 6 2018/10/15 16:39

DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad • Declaração de conformidade
Equipment Type • Uitrustingstype • Type d'équipement • Gerätetyp •
Tipo di apparecchiatura • Tipo de equipo • Tipo de equipamento
Glue Trap
Model • Modèle • Modell • Modello • Modelo • Malli
CT870
Application of Council Directives(s)
Toepassing van Europese Richtlijn(en) • Application de la/des
directive(s) du Conseil • Anwendbare EU-Richtlinie(n) •
Applicazione delle Direttive • Aplicación de la(s) directiva(s) del
consejo • Aplicação de directiva(s) do Conselho
Low Voltage Directive (LVD) 2014/35/EU -recast
of 2006/95/EC
EN 60335-1:2012 +AC:2014 +A11:2014 +A12:2017
+A13:2017
EN 60335-2-59:2003+A1:2006 +A2:2009
EN 62233:2008 +AC:2008
Electro-Magnetic Compatibility (EMC) Directive
2014/30/EU -recast of 2004/108/EC
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
Restriction of Hazardous Substances Directive
(RoHS) 2011/65/EU
EN 50581:2012
Producer Name • Naam fabrikant • Nom du producteur • Name
des Herstellers • Nome del produttore • Nombre del fabricante •
Nome do fabricante
Eazyzap
Producer Address • Adres fabrikant • Adresse du producteur •
Anschrift des Herstellers • Indirizzo del produttore • Dirección del
fabricante • Morada do fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande
Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und Norm(en)
entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y estándar(es)
arriba mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es) Directiva(s)
e Norma(s)
Date • Data • Date • Datum • Data • Fecha • Data
11th October 2018
Signature • Handtekening • Signature • Unterschrift
Firma • Firma • Assinatura
Full Name • Volledige naam • Nom et prénom • Vollständiger Name •
Nome completo • Nombre completo • Nome por extenso
Ashley Hooper
Position • Functie • Fonction • Position • Qualifica • Posición • Função
Technical & Quality Manager
CT870_UK_A5_v1_20181015.indb 7 2018/10/15 16:39

CT870_UK_A5_v1_20181015
CT870_UK_A5_v1_20181015.indb 8 2018/10/15 16:39