Echo PB-413H How to use

16
STARTING COLD ENGINE
• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the unit
firmly.
• (PB-413H):Rotatespringloadedthrottlearmdownwardtoacomfort-
able operating position.
PB-413H
1. Throttle Lever
Move throttle lever (A) to Wide Open Throttle position.
PB-413T
1. Throttle Lever/Stop Switch
Move throttle lever (A) rearward to Wide Open Throttle position.
Slide stop switch (B) forward to run position.
PB-413H, PB-413T
2. Choke
Move choke (C) up to Cold Start position ( ).
3. Purge Bulb
Pump purge bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4. RecoilStarter
Pullrecoilstarterhandle(E)untilenginefires,oramaximumof 5
pulls.
5. Choke
After engine fires (or 5 pulls), move choke lever to Run ( )
position. Keep throttle lever in wide open throttle position, and
pull recoil starter handle until engine starts and runs.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
move choke to “Cold Start” ( ) position, and repeat steps 4 & 5.
6. ThrottleLever
Move throttle lever to IDLE position, and allow engine to warm up
before use.
7. ThrottleLever
After engine warm-up, move throttle lever gradually to increase
engine RPM to desired operating speed.
A
PB-413H
PB-413T B
A
E
C
D

17
POWER BLOWER
OPERATOR'SMANUAL
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
PB-413H
1. Throttle Lever
Movethrottlelever(A) to IDLE DETENTposition.
PB-413T
1. Throttle Lever/Stop Switch
Move throttle lever (A) forward to idle position. Slide stop switch
(B) forward to run position.
PB-413H, PB-413T
2. Purge Bulb
Pump purge bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Pull recoil starter handle (E) and engine should start. Do not use
choke(C).
NOTE
If engine does not start after 5 pulls, use cold start procedures.
STOPPING ENGINE
PB-413H
1. Throttle Lever
Move throttle lever (A) to idle detent position and allow engine to
return to idle before shutting off engine.
2. Throttle Lever
Move throttle lever (A) to "O" (Stop) position.
PB-413T
1. Throttle Lever
Release thottle trigger (F). Move throttle lever (A) forward to idle
position and allow engine to return to idle before shutting off
engine.
2. Stop Switch
Slide stop switch (B) to Stop position.
WARNING DANGER
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
A
A
PB-413H
PB-413H
PB-413T B
A
PB-413T B
A
F
E
C
D