Eclipse ThermJet TJSR Series Mounting instructions

Thank you for purchasing burners from Eclipse. This Quick Instruction Guide will help with the unpacking and preparing
your burners for installation.
Figure 1.
Figure 2.
In order to protect the fragile components, self
recuperative burners are packaged and shipped partially
disassembled.
A standard shipment includes the burner air housing/
eductor/combustor assembly, the rear cover/nozzle
assembly, exhaust tube, extension flanges and spark
rods. Your packaging should be similar to Figure 1.
The exhaust housing and burner rear cover housing are
bolted to the frame of the shipping crate. A ratchet or
wrench will be required to remove those items from the
crate (Figure 2).
NOTE: Spark rods and gaskets are either secured in the
lower section of the crate or shipped in seperate
packaging. Ceramic exhaust tubes are also shipped
separately. Please do not forget to take care when
removing these items.
Quick Guide 208
2/9/2012
Eclipse ThermJet Self
Recuperative Burner
Model TJSR0020-TJSR0060

2Eclipse ThermJet Self Recuperative Burner, V5, Quick Guide 208 2/9/2012
Figure 3.
Figure 4.
Figure 5.
Each ceramic combustor is supported by a foam insert
(Figure 3). Please take caution when removing these from
the crate.
Foam insert
After the items are uncrated, remove the spark rod from
the protective tube (Figure 4). The spark rod must be
installed into the assembly prior to mounting the burner.
Remove the shipping paper from around the nozzle
(Figure 5).

3Eclipse ThermJet Self Recuperative Burner, V5, Quick Guide 208 2/9/2012
Figure 6.
Figure 7.
After removing the shipping paper, install the spark rod
(Figure 6)
After the rod is installed in the burner, the nozzle and rear
cover assembly can be inserted and attached to the air
housing.
At this point, your burner is ready to be installed. Please
follow the Installation Guide 325 that was supplied with
your order to complete the installation.

Quick Guide 208, 2/9/2012