EcoNet EVC200 User manual


Sept 30, 2022
Thank you for purchasing the Bulldog ZWave/Zigbee Smartthings complete Solution. This basic quick
start guide is designed to help you to Install Smartthings and add in your new leak prevention devices.
Note: This kit is considered an Enthusiast level kit and requires some extra steps to install and configure.
Contents:
1x Smartthings Hub
3x ThirdReality Zigbee Leak sensor
1x EVC200 Kit
1x EVC200 Controller
1x Power Adapter
1x Bulldog Motor Assembly
2x Mounting brackets, Bottom Pin Guide, 2x Guide Pin Assemblies
EVC200 Bulldog Quickstart Guide
This document
Getting Started:
Prepare Smartthings App and Hub
Download the Smartthings App on your iOS or Android Device
Use the + sign ->Add Device-> By brand -> Smartthings
Choose Smart Home Hub -> Smartthings Hub (IM6001V3P)
Follow the app directions to complete
Prepare Leak Sensors –ThirdReality
Open each leak sensor using a slot screwdriver
Insert batteries
Put leak sensor into Zigbee pairing mode
oHold down the small button until LED (on other side) turns red
o
oRelease the button. The LED will blink Blue
Scan for devices in Smartthings
Change the name of the Leak Sensor to something meaningful
Smartthings will download the latest EDGE driver for your Water Sensor

Prepare your EVC200 Bulldog Controller
Plug the 6 pin mini din (PS2) cord then the power cord into the EVC200 control unit.
In the Smartthings App, use the + sign ->Add Device-> By brand -> EcoNet Controls
Select Valve then on the next screen (Start)
Select your Hub and a room, Select Next
The screen will display “Press the button three (3) times.
Immediately press the button on the EVC200 controller 3 times quickly.
Wait and watch the Smartthings App. This can take over a minute to finish.
If the controller isn’t added after a minute. Press the button 3 times again.
If this still fails, close the Smartthings App and try again.
Create Automation so your Valve Closes when a Sensor is Wet
In Smartthings, Automations, Create Routines so that when a Sensor is wet, the Valve closes.

Sample Routine:
