ECR 4 Kids ELR-17255 User manual

Use the
Hex Tool
Use a Phillips
Screwdriver
Use a Phillips
Screwdriver
C
D
E
FG
H
I
J
K
L
Top Panel (1)
Left & Right
Side Panels (1/1)
Parts List
A
B
BEFORE ASSEMBLING, MAKE SURE YOU HAVE ALL THE PARTS
Lower Divider (3)Upper DIvider (4)
Upper Back Panel (1)
Lower Back Panel(2)
Hex Screws (30)
Cam Posts & Cam Locks (14/14)
Phillips Screws and Casters (16/4)
K1 K2
L1 L2
Upper Shelf (1)
Lower Shelf (1)
Bottom Shelf (1)
Batch ID Sticker
located on underside
Children climbing on furniture
can lead to death or serious
injury due to tipping secure unit
to wall using appropriate
hardware
5+ 5Storage and Tray Cabinet
Model# ELR-17255
Adult Assembly Required.
Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean orpull on unit forsupport.
- Neverleave children unattended.
- Do not place unit nearhigh heat ormoisture.
- Adult supervision recommended.
WARNING:
TOOLS INCLUDED
Hex Tool (1) TOOLS NEEDED
Phillips Screwdriver
San Diego, CA 92110 USA
www.ecr4kids.com
A1 A2

1
Install Lower Dividers to Bottom Shelf
2
Install the Casters onto Bottom Shelf 3
Connect Lower Shelf to Lower DIviders
4
Install Lower Dividers to Lower Shelf
Optional: Install the four Casters (L2) into the pre-drilled holes on the underside of the
Bottom Shelf (E), with four Phillips Screws (L1) per caster, using a Phillips screwdriver.
Install two Lower Dividers (G) on to the Bottom Shelf (E) with four Hex Screws (H) using the
Hex Tool.
Note: The groove on the Bottom Shelf is away from the ground.
Install four Cam Posts (K1) into the threaded plastic inserts on the underside of Lower Shelf (D)
with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Lower Shelf (D) Cam Posts into the holes on the top edge of the Lower Dividers (G).
Turn the Cam Locks (K2) clockwise with a Phillips screwdriver to lock the Lower Dividers (G)
onto the posts.
See Next Page
Batch ID Sticker
Place two Cam Locks (K2)
into the recessed holes on
each Lower Divider (G), with
the arrow facing the closest
edge.
Install one Lower Divider (G) on to the Lower Shelf (D) with two Hex Screws (H) using the
Hex Tool.
Note: The groove on the Lower Shelf is away from the ground.
Place two Cam Locks (K2)
into the recessed holes on
the Lower Divider (G), with
the arrow facing the closest
edge.

Connect Upper Shelf to Lower Divider
Install Upper Dividers to Upper Shelf
Install Right Side Panel
Connect Top Panel to Upper Dividers
5
6
7
8
Install eight Cam Posts (K1) into the threaded plastic inserts on the underside of Top Panel (B)
with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Top Panel (B) Cam Posts into the holes on the top edge of the Upper Dividers (F).
Turn the Cam Locks (K2) clockwise with a Phillips screwdriver to lock the Upper Dividers (F)
onto the posts.
Install the Right Side Panel (A2) on to the Top Panel (B), Upper & Lower Shelves (C, D) &
Bottom Shelf (E) with eight Hex Screws (H) using the Hex Tool.
Install four Upper Dividers (F) on to the Upper Shelf (C) with eight Hex Screws (H) using the
Hex Tool.
Note: The grooves on the Upper Shelf are away from the ground.
Install two Cam Posts (K1) into the threaded plastic inserts on the underside of Upper Shelf (C)
with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Lower Shelf (C) Cam Posts into the holes on the top edge of the Lower Divider (G).
Turn the Cam Locks (K2) clockwise with a Phillips screwdriver to lock the Lower Dividers (G)
onto the posts.
Note: The groove on the
Top Panel is away from
the ground.

Install Right Side Panel
Insert th Back Panels
9
10
C
a
r
e
f
u
l
l
y
R
o
t
a
t
e
U
p
r
i
g
h
t
Slide the Upper Back Panel (H) and Lower Back Panels (I) into the grooves on the Top Panel
(B), Upper & Lower Shelves (C, D) & Bottom Shelf (E) as shown, until fully seated into the
groove on the inside of the Right Side Panel (A2).
Tip: If the Back Panels do not slide in easily, wiggle the panels while pushing into place.
Install the Left Side Panel (A1) on to the Top Panel (B), Upper & Lower Shelves (C, D) &
Bottom Shelf (E) with eight Hex Screws (G) using the Hex Tool.
©2016 ECR4KIDS, LP Version: ELR-17255_2016.04.19
Care and Cleaning
Clean wood with a damp cloth or sponge
using warm water and mild soap. Wipe dry.
Do not place near heat, moisture or
vaporizer which may cause wood to warp
and peel.
Check for loose or worn parts periodically
and tighten or replace as necessary.
Record the manufacture date here.
Information is located on the Batch ID
sticker and on the shipping carton.
Save this sheet in an accessible place.
Model Number: ELR-17255
Factory Code: EP
Manufacture Date:
Batch ID Number: ECR2016-1184
(Located on Part #)
We appreciate your purchase of the 5+5 Storage and Tray Cabinet.
ECR4KIDS has made every effort to supply a quality product that with proper
use and care, will provide many years of trouble-free use.
Warranty: Visit our website for product specific warranty information at:
www.ecr4kids.com
If you experience any difficulties with this product, please email us at
[email protected] or call toll-free at (855) ECR-4KIDS
(Monday - Friday, 7:00am - 4:00pm Pacific Standard Time)
Please do not return to place of purchase as ECR4KIDS will
replace defective part(s) and/or product.
To prevent a tip-over tragedy:
Buy and install low-cost anchoring devices that can prevent TVs,
dressers, bookcases and other furniture from tipping. For more
information please visit www.ecr4kids.com/resources
Two Adults Recommended:
Carefully rotate unit upright.