ECR 4 Kids ELR-17256 User manual

Use the
Hex Tool
Use a Phillips
Screwdriver
C
D
E
F
G
H
I
J
Top Panel (1)
Left & Right
Side Panels (1/1)
Parts List
A
B
BEFORE ASSEMBLING, MAKE SURE YOU HAVE ALL THE PARTS
Left &Right
Side Dividers (1/1)
Shelf Bar(6)
Back Panel (3)
Hex Screws (34)
Cam Posts & Cam Locks (4/4)
J1 J2
F1 F2
A1 A2
Anchor Bar (1)
Middle Shelf (2)
Bottom Shelf (1)
Batch ID Sticker
located on underside
Must be drilled to mount to wall
per individual installation application
Wall Mount (1)
K
Organize and Play
Storage Cabinet
Model# ELR-17256
Adult Assembly Required.
Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on
unit for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
WARNING:
San Diego, CA 92110 USA
www.ecr4kids.com
Children climbing on furniture
can lead to death or serious
injury due to tipping secure unit
to wall using appropriate
hardware
TOOLS INCLUDED
Hex Tool (1)
TOOLS NEEDED
Phillips Screwdriver
Drill Driver
+ Drill Bits

1
2
Install Shelves to the Dividers 3Connect Lower Shelf to Lower DIviders
4
Install Bottom Shelf to Dividers Connect Top Panel to Upper Dividers
Install four Cam Posts (J1) into the threaded plastic inserts on the underside of Top
Panel (B) with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Top Panel (B) Cam Posts into the holes on the top edge of the Left & Right
Dividers (F).
Turn the Cam Locks (J2) clockwise with a Phillips screwdriver to lock the Left & Right
Dividers (F) onto the posts.
Align the slits on the Left and RIght Dividers (F) with the slits on Middle Shelves (D) as
shown and slide together until seated.
Place three Cam Locks (J2) into the recessed holes on the Anchor Bar (C).
Install three Cam Posts (J1) into the threaded plastic inserts on the underside of Top Panel (B)
with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Top Shelf (B) Cam Posts into the holes on the top edge of the Anchor Bar (C).
Turn the Cam Locks (J2) clockwise with a Phillips screwdriver to lock the Anchor Bar (C) onto
the posts.
C
a
r
e
f
u
l
l
y
R
o
t
a
t
e
U
p
r
i
g
h
t
See Next Page
Place two Cam Locks (J2)
into the recessed holes on
the Left & Right Dividers
(F), with the arrow facing the
closest edge.
Install the Bottom Shelf (E) on to the Left and Right Dividers (F) with four Hex Screws (I)
using the Hex Tool.
Two Adults Recommended:
Carefully rotate unit upright.
Note: Each divider
side with six holes
should face outward.
Tip: Groove for back panels should align with shelves.

Install Left Side Panel Install Right Side Panel
Insert the Back Panels
5
6
7
8
Slide the Back Panels (H) into the grooves on the Top Panel (B), Middle Shelves (D) & Bottom
Shelf (E) as shown, until fully seated into the groove on the inside of the Left Side Panel (A1).
Tip: If the Back Panels do not slide in easily, wiggle the panels while pushing into place.
Install the Right Side Panel (A2) on to the Top Panel and anchor Bar (B,C), Middle Shelves
and Shelf Bars (D,G) & Bottom Shelf (E) with thirteen Hex Screws (I) using the Hex Tool.
Install Shelf Bars
Align pre-installed dowels on six Shelf Bars (G) with holes on Left & Right Dividers (F) and
push into place. Secure in place with six Hex Screws (I) using the hex tool.
Install the Left Side Panel (A1) on to the Top Panel and anchor Bar (B,C), Middle Shelves and
Shelf Bars (D,G) & Bottom Shelf (E) with thirteen Hex Screws (I) using the Hex Tool.

©2016 ECR4KIDS, LP Version: ELR-17256_2016.04.20
Care and Cleaning
Clean wood with a damp cloth or sponge
using warm water and mild soap. Wipe dry.
Do not place near heat, moisture or
vaporizer which may cause wood to warp
and peel.
Check for loose or worn parts periodically
and tighten or replace as necessary.
Record the manufacture date here.
Information is located on the Batch ID
sticker and on the shipping carton.
Save this sheet in an accessible place.
Model Number: ELR-17256
Factory Code: EP
Manufacture Date:
Batch ID Number: ECR2016-1184
(Located on Part #)
We appreciate your purchase of the Organize and Play Storage Cabinet.
ECR4KIDS has made every effort to supply a quality product that with proper
use and care, will provide many years of trouble-free use.
Warranty: Visit our website for product specific warranty information at:
www.ecr4kids.com
If you experience any difficulties with this product, please email us at
[email protected] or call toll-free at (855) ECR-4KIDS
(Monday - Friday, 7:00am - 4:00pm Pacific Standard Time)
Please do not return to place of purchase as ECR4KIDS will
replace defective part(s) and/or product.
To prevent a tip-over tragedy:
Buy and install low-cost anchoring devices that can prevent TVs,
dressers, bookcases and other furniture from tipping. For more
information please visit www.ecr4kids.com/resources
9Install the Wall Mount
Consult a professional Handyman, Carpenter or Maintenance person to install the wall mount.
They can determine suitable wall mounting hardware, available from your local home improvement
store, for your particular application.
The Wall Mount (K) should be secured in a minimum of two locations, preferably into wall studs.