ECR 4 Kids ELR-24103 User manual

Adjustable
Swivel Glide
E1 E2
F1 F2
Use the 5mm Hex Tool
Use both 4mm Hex Tools
Upper X-Frame (1)
Lower X-Frame (1)
Book Box (1)
Parts List
A
B
C
D
E
F
BEFORE ASSEMBLING, MAKE
SURE YOU HAVE ALL THE PARTS
Cross Supports (2)
Lower Legs (3/1)
Double Hex Post & Screws (5/5)
Hex Screws (4)
G
1Connect the X-Frames
2Connect the Book Box
Open Front Desk
- RTA Version -
Model# ELR-24103
Adult Assembly Required.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on
unit for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
WARNING:
TOOLS INCLUDED
Hex Tool - 5mm (1)
Hex Tool - 4mm (2)
San Diego, CA 92110 USA
www.ecr4kids.com
Place the Upper X-Frame (B) on top of the Lower X-Frame (C) and connect at the center
cross-over point with one Double Hex Post & Screw (F1/F2) and tighten using both of the
4mm Hex Tools.
Install the Book Box (A) to the connected X-Frames (B/C) with four Double Hex Post &
Screws (F1/F2) using both of the 4mm Hex Tools.

3Install Lower Legs at the Desired Height
4Level the Desk
©2016 ECR4KIDS, LP Version: ELR-24103_CM_2016.01.21
Care and Cleaning
Clean unit with a damp cloth or sponge
using warm water and mild soap. Wipe dry.
Do not place near heat, moisture or
vaporizer which may cause panels to warp
and peel.
Check for loose or worn parts periodically
and tighten or replace as necessary.
Record the manufacture date here.
Information is located on the Batch ID
sticker and on the shipping carton.
Save this sheet in an accessible place.
Model Number: ELR-24103
Factory Code: CM
Manufacture Date:
Batch ID Number:
(Located on Part A)
We appreciate your purchase of the RTA - Open Front Desk.
ECR4KIDS has made every effort to supply a quality product that with proper
use and care, will provide many years of trouble-free use.
Warranty: Visit our website for product specific warranty information at:
www.ecr4kids.com
If you experience any difficulties with this product, please email us at
[email protected] or call toll-free at (855) ECR-4KIDS
(Monday - Friday, 7:00am - 4:00pm Pacific Standard Time)
Please do not return to place of purchase as ECR4KIDS will
replace defective part(s) and/or product.
Install the Cross Supports (D)
and Lower Legs (E) onto the
X-Frames (B/C) with four Hex
Screws (G) at the desired
height, using the 5mm Hex Tool.
Tip: Double check that all legs
are installed at the same height.
Identify the Adjustable Swivel
Glide Lower Leg (E2), rotate to
remove any wobble in the desk.