Eden Cozy Arbor Bench User manual

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. End Closure Caps (for Bench Supporting Arms) (4)
2. Bench Supporting Arms (2)
3. Bench Slats (4)
4. Bench Supporting Slat (1)
5. Hardware (in plastic bag)
a) 1/2”x 5 1/2“ Galvanized Steel Hollow Dowels (8)
b) 3/8”Dia x 6“ Long Galvanized Carriage Bolts (8)
c) 3/8”Galvanized Locking Washers (8)
d) 3/8”Galvanized Nuts (8)
e) 1 1/2“ Self-Auguring Stainless Steel Screws (12)
f) 1/2”Drill Bit (1)
Tools You Will Need
• Cordless Drill
• Hammer
• Level
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e.shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’ for unobstructed assembling.
• You should not need to use excessive force when assembling components.
The Cozy Arbor Bench
Please read through before starting assembly.
ASSEMBLY INSTRUCTIONS
5 a b
1
www.edenarbors.com
Not to Scale
2
4
3
2
3.5
24
42
Designed to be Installed with the Monaco, Vienna and Florence Arbors
(Purchase Separately)
c d f
1/2”
e
1
Ver 1/Nov 2008

STEP TWO
Layout one supporting arm and insert the four bench slats.
Slide the other supporting arm over the exposed end of the
four bench slats.
Attach the supporting bench slat on the underside of the bench
at the midpoint - invert as necessary (2 screw points are included
per bench slat for a total of eight).
Assemble the Bench
2
3
2
EDEN ARBORS, 1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: [phone] Toll Free Fax: [phone]
www.edenarbors.com
3
2
STEP ONE
Identify a marking line at 21”above the ground on all the arbor posts.
Align the top of the bench supporting arms with the marked lines
(check to determine level) and identify the drill points necessary for
the supporting bolts.
Drill out the holes accordingly.
Drill the Arbor Posts
1
2
4
STEP THREE
Align the bench supporting arms with the pre-drilled holes
(made in Step #1), on the posts.The four bench slats should be
positioned towards the back of the arbor.
Slide steel galvanized hollow dowels thru the supporting arms
and into the posts (this may require a hammer).
Insert carriage bolts from the inside of the arbor posts through
the supporting arm and install lock washer and nuts accordingly.
Insert closure cap and install screw in pre-drilled hole to lock
the cap unto the bench supporting arms. Repeat accordingly.
Connect the Assembled Bench
to the Arbor Posts
1
2
3
(Two people required for this step).
3
21”
1
1
2
3
1
3
2
1/4”
4
1