EF EFCH 6101 HM SS User manual

THE BEAUTY OF SIMPLICITY
USER MANUAL
SLIM HOOD EFCH 6101 HM SS
EFCH 9101 HM SS

Table of Contents
From the Manufacturer
Specifications
SAFETY: Read this before installation
Description of Parts
Operation Mode
Installation
Operation
Cleaning & Maintenance
Troubleshooting
2
3
3
4
5
6
8,9
10
10
11

From the Manufacturer
This appliance and the packaging are produced by processes that
minimize waste and respect the environment.
Please help us to continue the protection of the environment
by disposing the packaging in a correct way.
Safety!
Please do not allow young children to play with the plastic bag
packaging.
Before disposing of any old appliances, be sure to cut off the power cord
so that others will not be endangered by a defective electric appliance.
Specifications
Input: 220-240V 50Hz
Power
2 motor version:
Lamp:
Dimensions
60cm version:
90cm version:
W600xD495xH140mm
W900xD495xH140mm
3
2×85W
2x40W

SAFETY: Read this before installation
Do not connect the appliance if there are obvious signs of transportation
damage.
Read this user manual thoroughly before attempting to use this appliance
Installation and repair should be attempted only by qualified technical
personnel.
It is dangerous to modify any part of this appliance.
The manufacturer declines all responsibility in case of failure to adopt
proper safety measures.
Ensure the location in which this appliance is installed has good,
permanent ventilation.
The distance between the bench top to the lower part of the hood must not
be less than 65cm or higher than 75cm.
Check that the voltage in your area is correct before plugging in.
The electrical connection of this appliance must be connected to earth.
Green & yellow = EARTH
Blue = NEUTRAL
Brown = LIVE
Multiple plugs and extension cables must not be used. Overload is
dangerous and may cause a fire.
Ensure that the power supply cord is free from any heat source or sharp
objects.
The appliance should be switched off and the electrical supply
disconnected before any cleaning or maintenance work can be carried
out.
4

Description of Parts
2 Charcoal filters
3 Aluminium filters( for 90CM)
6 Screws
5
2 Aluminium filters( for 60CM)
2 screws are used for fixing hood unit on the
wall as Installation Step 3.
Other 4 screws are used for fixing hood unit to
cabinet as well if necessary
Stopper

Operation Mode
This appliance can be configured to operate in ducted mode or re-circulation mode:
B. DUCTED MODE (VENTED MODE)
In ducted mode, cooking fumes are vented outdoors through suitable connection of
125mm diameter. In this mode, only the aluminium filters are installed.
A. RE-CIRCULATION MODE
This appliance is pre-configured with re-circulation mode. In re-circulation mode,
fumes are filtered for grease and odour through the aluminium grease filters and
the charcoal filters respectively and re-introduced into the kitchen environment.
Both the aluminium grease filters and the charcoal filters must be installed.
Ducted hole must be
covered with stopper
6

7
Setting screws
Unscrew
- Install the outlet connector (125mm) (connector and flexible
hose not supplied).
- Remove the charcoal filters (not required for ducted mode).

Installation
STEP 1: Remove the aluminium filters and place them in a safe location to
avoid damage.
STEP 2: the 2 screws on the wall (follow the required length as stated below).
8
538 mm for 600mm hood
838 mm for 900mm hood

Installation
STEP 3: H
9
STEP 4:
STEP 6: Put back the aluminium filters.
STEP 5: .

Operation
The hood is equipped with 3 speed control.
Use the low speed for simmering, medium speed for light cooking. Use the high
speed for frying or heavy cooking.
It is also equipped with a lamp to illuminate your cooking area when needed.
turns off switch
low speed setting
medium speed setting
high speed setting
light switch
Cleaning & Maintenance
SURFACES: Wash with warm soapy water and a soft sponge. Never use
abrasive detergent, scouring pads, steel wool or solvents on any part of this
appliance as this will cause irreparable damage.
ALUMINIUM GREASE FILTERS: Wash in the dishwashers or soak the panels
in a degreasing agent for an hour, then rinse off.
CHARCOAL FILTERS (only for re-circulating mode): Charcoal filter cannot be
reused. They must be replaced once a year or depending on the frequency of the
appliance usage.
For this appliance to function effectively, regular maintenance is a must. Clogged
filters restrict airflow and may cause the motor to overheat.
10

Troubleshoot
Not functioning
No electrical supply
Check that the plug is
connected
Check that the mail
switch is turned on
Poor airflow
Aluminium grease filters
clogged
Clean the filters and
replace when dry
Charcoal grease filters
clogged
Replace charcoal
filters with new sets
Motor running but
no airflow
Butterfly valve jammed
Contact Customer
Service
Motor cut off after a
few minutes
High temperature safety
device activated
The kitchen is not
sufficiently ventilated
The hood is installed too
near to the cooking stove
The hood must be at
least 65cm from stove
Strong cooking
smell
Charcoal filters not
installed
In re-circulating mode,
charcoal filters must be
installed
Charcoal grease filters
clogged
Replace charcoal
filters with new sets
Oil dripping onto
stove
Aluminium grease filter
saturated
Wash the aluminium
grease filters
Whirring sound
Foreign object in contact
with fan blade
Contact Customer
Serice
Symptoms Possible Cause Action
11

For original parts & reliable service