EF EFCH 9401 HM SS User manual

TELESCOPIC HOOD EFCH 9401 HM SS
THE BEAUTY OF SIMPLICITY
USER MANUAL

Table of Content
•From the Manufacturer 3
•Specifications 3
•Description of Parts 4
•Safety Regulations 5
•Control switch operation 6
•Re-circulating 7
•Installation Instructions 8
•Electrical Connection 9
•Cleaning & Maintenance 9
•Troubleshooting 10
•Schematic Diagram 11

Dear Customer,
Thank you for having purchased and given your preference to our product. This manual provides a
means to make full use of the features of this product. We recommend that you read this manual for
best performance and to extend the life of your appliance.
Please preserve this manual for future use, in the event that doubts arise relating to the operation
• This appliance and the packaging are produced by processes that minimize waste and friendly
to the environment.
• Please dispose the packaging in an environmentally friendly manner
• Please do not allow young children to play with the plastic film and packaging as this may
result in suffocation.
• Before disposing of any old appliances, be sure to cut off the power cord so that others will not
be endangered by a defective electric appliance
Production Dimension

90cm version :900x302x180mm
3
:220-240V/50Hz
: 2×85W
: 2×40W
: 250W
Input
Motor
Lamp
Total Power
Specifications
From the Manufacturer
Safety!

Description of Parts
Extractable
Group
Light
Switch
Motor
Control
Filters
Charcoal
Filter
Lamps
4
4 screws
4 screws（5mm×L15mm) are used for hanging the hood to the ceiling.

•
Do not connect the appliance if there are obvious signs of transportation damage.
• Read this user manual thoroughly before attempting to use this appliance.
•
Installation and repair should be attempted only by qualified technical personnel.
• Do not modify any part of this appliance
•
Ensure the location in which this appliance is installed has good, permanent ventilation.
•
The distance between the cooking appliance to the lower part of the hood must not be
less than 65 cm or higher than 75cm.
• Check that the main voltage in your area corresponds to the voltage of the appliance before
pugging in.
• The electrical connection of this appliance must be connected to earth.
Green & Yellow = EARTH
Blue = NEUTRAL
Brown = LIVE
• Multiple plugs and extension cables must not be used. Overload is dangerous and
may cause a fire.
• Ensure that the power supply cord is free from any heat source or sharp objects.
•
The appliance should be switched off and the electrical supply has to be disconnected
before any cleaning or maintenance work can be carried out.
•
The company declines all responsibilities in case of failure to adopt proper safety
measures stated in this manual.
Safety Regulagtions
5

Operation
By pressing the button shown in the below, you will be able to control the functions of the
extractor.
To achieve better extraction, we recommend switching on the power(by pulling out of
extractor) a few minutes before starting to cook (3—5 minutes) so that the air flow is
continuous and stable when extracting fumes.
Likewise, keep the power on for a few minutes when cooking is completed to allow all fumes
and odors to be expelled.
Light
ON
Speed
Low
Off Off
Automatic High
6

7
RE-CIRCULATING MODE
•
The cooking smells and odours are passed through a cleaning filter. Once filtered, the air is
recirculated into the kitchen through the grille on the upper part of the front on the appliance.
Caution:
In recirculating mode, charcoal filter is to be fitted.
Re-circulating
This appliance is configured to operate in the re-circulating mode ONLY.

Installation Instructions
Cabinet Mounting
- Drill 4 holes of Ø 6mm at the bottom of the cabinet according to the positions of the screw holes
on top of the cooker hood (A)
- Put the one-way valve on the cooker hood screw holes and lift the cooker hood to the bottom of
the cabinet.
- Tighten the hood with the 4 screws provided to the four holes at the bottom of the cabinet (B)
- Make the electrical connection
8
808mm
220mm
20mm
∅6mm
- Unless otherwise specified, the distance between the cooking appliance to the lower part of the
hood must not be less than 60cm for electric cookers and 65cm for gas cookers.
A
B

Electrical Connection
Before completing any connection, make sure the house voltage corresponds to the voltage
indicated on the label affixed inside the appliance
It is advisable to call a qualified technician to make the electrical connection.
Appliance fitted with plug
Connect it to a socket which conforms to current regulations. If you intend to connect it directly
to the electric mains, remove the plug and fit an approved bipolar switch with a minimum
contact opening of not less than 3mm.
If the plug is not accessible once it has been inserted in the socket, it will however be
necessary to fit an approved bipolar switch with a minimum contact opening of no less than
3mm.
Appliance without plug
Fit an approved plug or an bi-polar switch with a minimum contact opening of no less than 3mm.
The company is not liable for any problems caused by the user’s failure to comply with the above
instructions
9
Cleaning & Maintenance
Regular maintenance and cleaning ensures good performance and reliability, while
extending the working-life of the appliance.
SURFACE :
Wash with warm soapy water and a soft sponge. Never use abrasive detergent, scouring
pads, steel wool or solvents on any part of this appliance as this will cause irreparable
damage.
Note:Never use metallic scouring pads or abrasive products that could damage the surface.
Filter Cleaning:
Aluminium Grease Filters : Wash in the dishwashers or soak the panels in a degreasing
agent for an hour, then rinse off. The filter must be cleaned at least once a month or
depending on the frequency of appliance usage.
CHARCOAL FILTERS:(only in re-circulating model): Charcoal filter cannot be reused. They must be
replaced with the appropriate types once a year or de-pending on the frequency of appliance usage.
For this appliance to function effectively, regular maintenance is a must. Clogged filters restrict airflow
and may cause the motor to overheat.
BULB REPLACEMENT:Before attempting to replace the light bulb, make sure that the light
switch is turned off. Remove the grease filter to access the lamp area. Remove the
damaged light bulb and replace an bulb with maximum 40W.

Troubleshooting
Symptoms
Possible Cause
Action
Motor does not function
No electrical supply
-Plug and main switch not
connected
-Damaged switch or short
circuit
-Check that the plug is
connected and the main
switched is turned on.
-Check if the switch is
damaged or short circuit –
replace or repair.
Poor airflow
-Distance between the cooking
appliance and the hood is too
high
-Fan operation speed is too low
-Charcoal filters clogged
-Adjust installation height
-Replace motor or
capacitor – contact
technician
-Replace charcoal filters
Motor running but
No airflow
Air flow blade is
jammed
Adjust air flow blade -
contact technician
Motor shut off after a few
minutes
-High temperature – safety
device activated
-The hood is installed too near
to the cooking appliance
-The kitchen is not
sufficiently ventilated
-Adjust installation height –
must be at least 65cm
from cooking appliance
Strong Vibration
-Hood installed incorrectly
-Fan installed incorrectly
-Fan is damaged
-Reinstall the hood
correctly
-Reinstall the fan correctly
-Replaced or repair
Strong cooking smell
Charcoal filters not
installed
In re-circulating mode,
charcoal filters must be
installed
Oil dripping onto stove
Aluminium grease filter is
saturated
Wash the aluminium
grease filters
Whirring sound
Foreign object in contact
with fan blade
Contact technician
In the event of any uncertainties arise on appliance or if the appliance is not function properly,
please stop using it and contact our customer service immediately
10

Schematic Diagram
2 motor version
11

Please note:
Casa (S) Pte Ltd reserves all rights to the final interpretation of the content of this manual.
Customer will not be notified in the event of any amendments to the content.
For original parts & reliable service:
CASA (S) PTE LTD
15 KIAN TECK CRESCENT,
SINGAPORE 628884
TEL:[phone]
FAX:[phone]
Email:[e-mail]