EF EFCH 9402-AL User manual

COOKER HOOD EFCH 9402-AL
THE BEAUTY OF
USER MANUAL

- 1 -
User Instruction
Note: Please read the instructions before installation.
Your cooker hood is for domestic use only, not suitable for barbecue and other
commercial use.
Any installation work must be carried out by a qualified electrician or qualified
installer.
The cooker hood and the aluminium filters should be cleaned regularly to maintain in
good working condition.
Before cleaning, always ensure that you have switched off your cooker hood.
Clean the cooker hood as shown in the instruction manual.
Do not dry your cooker hood over fire.
If there is any fault with your cooker hood, please call the service department
appointed by agent for servicing.
If there is any fault with your cooker hood, please call the service centre at:
Casa (S) Pte Ltd
15 Kian Teck Crescent Singapore 628884
Service Hotline: [phone]
Service Fax: [phone]
Email: [e-mail]

- 2 -
INSTALLATION INSTRUCTIONS
Way one:
1 The cooker hoods should be placed at a distance of 65-75cm from the cooking surface
for best effect.
2 To install onto the wall drill 2 holes of Ø8mm on a suitable place according with the
centre distance of hole in the back of the cooker hood.
3 Insert the nut into the holes.
4 Insert the screws into the nuts and tight.
5 Put up the cooker hood onto the tighten screws.
6 Put the one way valve onto the cooker hood.
Way two:
1 Drill 6 holes of 4mm diameter at the bottom of the hanging cupboard
2 Put the one way valve on the cooker hood, then install the cooker hood on the bottom of
the cupboard, tighten the hood with enclosed 6 screws.
3 Install the adjusted board on the bottom of the hood in order to keep out the gap
between hood back and cupboard.
6 0
1 9 4
5 1 6
ATTENTION: should the lamps not work, make sure they are well
tightened

- 3 -
OPERATION
1 Connect the plug into the power.
2 Choose the ducting mode or the recirculation mode as you need (for Front-
re-circulating models only) :
3 Push the switch ①into “I”, the lamp be on; push into “0”, the lamp be off.
4 Push the switch ②into “I、II、III”, the motor will be on “low、mid、high” three
speeds, push into “0”, the motor will be off.

- 4 -
USE AND MAINTENANCE
It is recommended to operate the appliance prior to cooking.
It is recommended to leave the appliance in operation for 15 minutes after cooking is
terminated in order to completely eliminate cooking vapours and odours.
If the appliance is not used, please turn off.
Don’t use or stop use if the appliance is damaged especially the supply cord and the case.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Don’t immerse the appliance in liquid.
The exhaust air must not be discharge into a flue which is used for exhausting fumes from
appliance burning gas or other fuels.
Regulations concerning the discharge of air have to be fulfilled.
The proper function of the cooker hood is conditioned by the regularity of the maintenance
operations, in particular, the active carbon filter.
The anti-grease filters capture the grease particles suspended in the air, and are therefore
subject to clogging according to the frequency of the use of the appliance.
In order to prevent fire hazard, it is recommendable to clean the filter at a maximum of 2
months by carrying out the followings:
-Remove the filters from the cooker hood and wash them in a solution of water and neutral
liquid detergent, leaving to soak.
-Rinse thoroughly with warm water and leave to dry.
-The filters may also be washed in the dishwasher.
The aluminum panels may alter in color after several washes. This is not cause for
customer complaint nor replacement of panels.
Clean the fan and other surface of the cooker hood regularly using cloth moistened with
denatured alcohol of non abrasive liquid detergent.
Before any repair on the cooker hood, detach all plugs.
Replace filters approximately every 4 months.