EGAN ACTSTBMG User manual

2Fasteners (Clamp Down Knobs
2Machine Screws
5-YEAR LIMITED WARRANTY
Egan warrants the frame construction and the finish of all its products for normal
and reasonable use for a period of five years from the date of invoice. This
warranty does not apply to components not manufactured by Egan. No warranties
other than those contained herein shall be implied. All decisions of workmanship,
failure, misuse, and abuse remain with Egan. Items may only be returned with
prepaid shipping, and with Egan’s prior written consent. This warranty does not
apply to defects resulting from negligence, lack of normal maintenance, or
improper cleaning.
ADJUSTABLE
FLIPCHART TEARBAR
ACTSTBMG
ASSEMBLY INSTRUCTIONS
INCLUDED HARDWARE:
Reference #024H227_R2 8/04:PDF ©2004 Egan Visual Inc. Printed in Canada.
nPhillips Screw Driver
REQUIREMENTS:
Egan Visual Inc.
North America
1-800-263-2387
International
[phone]
email: [email protected]
www.egan.com

INSTALLATION
NOTE:
Handle the Tear Bar edges with care.
PICTURE A
1. Unscrew the clamp down knobs and raise the cover
to an upright position.
PICTURE B
2. Attach the tearbar to the board using the two machine
screws provided. Insert the screws through the predrilled
holes in the tearbar, and into the existing threaded
fittings in the board. Tighten until snug.
PICTURE C
3. Hang the flipchart on the adjustable Hanger Pins.
The pins slide to adjust for hole centres as necessary.
4. Close the cover and secure it by tightening the clamp
down knobs.
A
B
CLAMP
DOWN
KNOB
CLAMP
DOWN
KNOB
TEAR BAR
MACHINE
SCREW
HANGER PIN
FLIPCHART
PAD
C