
5. Before starting up
Before you connect the appliance to the mains supply
make sure that the data on the rating plate are
identical to the mains data.
Assembly of the steady grip
Push the steady grip (Fig. 3/Item 3) in the direction of
the arrow onto the motor housing (Fig. 3) and secure
(Fig. 4) on both sides with 2 screws (Fig. 4/Item 9).
6. Operation
The hedge trimmer is equipped with a two-handed
safety switch. The machine works only when the
switch on the steady grip (Fig. 5/Item A) is pressed
with one hand and the switch on the handle (Fig.
5/Item B) is pressed with the other hand.
Releasing any of the switches will bring the hedge
trimmer to a stop.
In so doing, please check the running of the
blades.
쎲Please check that the blades function correctly.
The blades cut on both sides and run in opposite
directions to each other, for guaranteed high
cutting performance and quiet operation.
쎲Fasten the extension cable to the cable holder
before starting to use the machine (see Fig. 5).
쎲For use in the open air you must only use
extension cables certified for the purpose.
Tips on use
쎲The hedge trimmer can be used not only for
trimming hedges but for trimming shrubs and
bushes as well.
쎲For optimum trimming performance, guide the
blade teeth at an angle of approx. 15° to the
hedge (see Fig. 6).
쎲Since the blades cut on both sides and run in
opposite directions to each other, you can trim in
both directions (see Fig. 7).
쎲To achieve a hedge with a uniform height it is
recommended that you stretch a piece of string
along the edge of the hedge for guidance. Then
simply cut away all twigs projecting above the
line (see Fig. 8).
쎲The sides of the hedge should be trimmed with
arc-type movements from below upwards (see
Fig. 9).
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
쎲Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
쎲We recommend that you clean the device
immediately each time you have finished using it.
쎲Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
8.2 Maintenance
쎲Um stets beste Leistungen zu erhalten, sollten
die Messer regelmäßig gereinigt und geschmiert
werden. Entfernen Sie die Ablagerungen mit
einer Bürste und tragen Sie einen leichten Ölfilm
auf (siehe Bild 10).
쎲There are no parts inside the equipment which
require additional maintenance.
쎲Zur Aufbewahrung kann die Heckenschere mit
passender Schraube und Dübel an der Wand
befestigt werden (siehe Bild 11).
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
10
GB
Anleitung_BG_EH_5747_SPK7:_ 21.09.2010 13:32 Uhr Seite 10